20 Most Recent HP PSC 2175 All-In-One InkJet Printer - Page 7 Questions & Answers

Does your computer recognize when you plug it into it? Have you installed the software/drivers for the printer? You can download them at the following link just select your operating system:
http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?lc=en&dlc=en&cc=us&os=228&product=90809
Then run the software after you download. If you need further assistance let me know.
Thank you,
Lee

Here's the HP solution for that issue.
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c02205477&cc=us&lc=en&dlc=en&product=90809

You should use the Installation CD that comes with the printer.
If you don't have it, look for them on the manufacturer's web site.
Good luck

Don't forget to rate this answer if it helps

Hi the first thing you need to do is got into your control panel on your computer then choose add and remove software now scroll down the list until you find the printer and remove any drivers and software for this printer, it may ask you then to reset your computer to remove the software fully if you are asked to do this then do it, if not then click on the link below and down load the latest drivers from the site in the link below make sure you choose your operating system then install the drivers and software and you should find that will solve your problem

CLICK HERE

let me know if you have any problems installing the software and drivers from the link i gave you ok

You are out of ink.

I hope this link can help you

http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&dlc=en&cc=nz&lang=en&docname=buu05212&product=90809

At these cases usually the printer also refuses to print. There is a coruption at the communication data or the drivers. I suggest you to reinstall the drivers. In case you don't have them, here is a link for you to choose your operating system and download the latest official version.

In case of a problem or clarification, don't hesitate to post me a reply.
If you are satisfied, accept my solution.

Thanks and regards
Stelios
direct FixYa link: http://www.fixya.com/users/technical114

The lamp of the scanner is the problem.

The problem could be as simple as the scanning mechanism which sweeps across the sheet being dirty...

else you will have to send it for repairs.

alignment is out...
or refilling problem

Click Start
Click Settings
Click Control Panel
Click Printers
Right-mouse click on your HP printer
Click Properties
Click HP Toolbox
Run the HP Toolbox to query the ink-levels.

Follow 'How to Scan' number either 2 or 3 or 4 or 5 from the following link :-

http://h10025.www1.hp.com/ewfrf/wc/searchResults?tmp_qt=how+to+scan&tmp_product=HP+PSC+2175+All-in-One+Printer&product=90809&lc=en&dlc=en&cc=us

Hi there,

Well you can please follow the below steps -
1. Follow this document for a carriage jam problem (follow the link -) 

http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&dlc=en&cc=us&docname=c00042632

2. Try the firmware update, this resolves many carriage and "remove and check cartridge" problems.

http://h10025.www1.hp.com/ewfrf/wc/softwareDownloadIndex?dlc=en&lc=en&os=228&product=90809&lang=en&cc=us&softwareitem=oj-14037-3

3. If the carriage movement is normal, remove the cartridges and clean the copper contacts with soft cloth and distilled water and replace them."Remove and check cartrdige" should be resolved.

Good Luck!!

Thanks for using FixYa!!

Please try downloading and installing the latest version of the driver from the support site link below.

http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?os=228&lc=en&cc=us&dlc=en&sw_lang=&product=90809#N1182

Robert from Blitware

Hi! Is the usb cable properly connected? If it is, the first course of action is to try putting the printer on a different usb port. This could work. Hope this helps and have a good one!

Verify that BOTH cartridges are in good condition. Both cartridges must be working for the alignment to be successful. If one (or both) are bad, alignment will not complete. It is also possible that the cartridge you just replaced is defective. This problem is almost always caused by a bad or empty cartridge.

If there are no errors with the printer (offline or other issues), you may have a problem with the spooler. You need to stop and restart the service. One way to do this in Windows is from the Command Prompt (Run As Administrator for Vista or Win7). Start > All Programs > Accessories > Command Prompt (right click on the option to Run as Administrator).

At the first prompt, type "net stop spooler" without the quotes and hit enter. At the next prompt, type "net start spooler" again without the quotes and hit enter. (Type Y if you get a query about the Fax system after the first command.) When the second command completes, reboot the computer and try printing again.

I hope this helps.

Cindy Wells

Hi

Thank you for your query

Your problem statement does not give anyinformation but I am assuming you want the driver software for your printer

Please click on the link below to download and install the driver

http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?lc=en&dlc=en&cc=us&lang=en&product=90809&

Regards
Shauqat