20 Most Recent HP LaserJet 1300 Printer - Page 4 Questions & Answers

When printing or copying, paper will not pick up or feed into the HP LaserJet 1000, 1200 or 1300 series product causing paper jams or wrinkled output. Symptoms are as follows:

• The pickup roller will spin and try to pick paper.
• The paper will partially feed into the product accompanied by a crackling, crunching noise then jamming.
• The paper may feed all the way through the paper path accompanied by a crackling, crunching noise. The output will be skewed and wrinkled.

SOLUTION: Reposition the black Mylar light shields back into the proper position.

1. Unplug the power cord from the product.
2. Remove the paper and paper input tray.
3. Slide hands, palms side up, into the paper input tray cavity (see Figure 1) until the fingertips reach the end of the cavity. Figure 1: Paper input tray cavity
4. Bend fingers up to push the black Mylar light shields back into place. The proper position of the black Mylar light shield will be flat.
5. Reconnect the power cord.
6. Print a self-test/configuration page to verify product is functioning correctly.

i don't have priter driver for HP Laser Jet 1300 printer, can i download it, how to download it?

go to printers and then select your printer and set as defaultthat will print your doc, instead of saving it as a pdf

one possible cause would be the nozzle of your cartridge maybe their is already a clog that blocks the continuous flow of your ink, try to clean the head by using the maintenance software. Go to control panel>printers>properties>printing preference>locate the maintenance then try to access the cleaning of your cartridge, I'm not sure which location of the cleaning of head better to check all the menus. Hope it helps thanks.

The last time I had a problem like this with an HP laserjet the problem turned out to be the need for increased memory in the printer and replacing a faulty memory module. Check your memory modules in that laserjet and make sure you aren't overloading the printers ability to process the information.

Paper might be roller on teflon sleeve, take out fuser from the printer, remove paper gently to avoid damage to teflon, after removing the paper observe that is there toner particles deposited on teflon sleeve, if observed replace the teflon sleeve,other wise this problem will repeats again & again.
Note: for this process technical skills required.

http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?prodNameId=238328&locale=en_US&taskId=135&prodTypeId=18972&prodSeriesId=238320

Pl find the link for the drivers hplj 1300, win7_32bit
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=18972&prodSeriesId=238320&prodNameId=238322&swEnvOID=4062&swLang=8&mode=2&taskId=135&swItem=lj-95984-2

In the back there is another lid. As I remember it opens only half-way. When you open it the jammed papers can easy be removed.

Is a toner cartridge problem (Q2613A), try witn another.

replace the tooner if problem persists then replace the teflon

you should contact any service centre.If you are not itself.
Treq Bin Mostaq
Bangladesh

if the toner is not seated properly the orage light will blink
open the door remove the toner fix it back and close the door forcely.this will solve the problem

You can download the HP printer drivers from their supportWEB site. Please click on this link and
select your model printer to download:- http://welcome.hp.com/country/us/en/support.html