20 Most Recent
HP OfficeJet 6210 All-In-One InkJet Printer - Page 2 Questions & Answers
How do I print the
Hi,
Follow the steps below to print Fax Logs for already received faxes
-
Press Setup
, and then press 2
.
This displays the Print Report menu.
-
Press the Right arrow
button to scroll through the following report types:
-
Fax Report Setup:
prints the automatic fax reports as described in
Generate reports automatically.
-
Last Transaction:
prints details of the last fax transaction.
-
Fax Log:
prints a log of approximately the last 30 fax transactions.
-
Speed Dial List:
prints a list of programmed speed-dial entries.
-
Self-Test Report:
prints a report to assist in diagnosing print and
alignment problems.
-
After the desired report is highlighted, press OK
.
Also, Click on the link below for more information about Fax settings on your printer
Fax Settings* Please rate this solution with Thumbs up and Testimony to help us improve providing support
Left and righ hinge is broken on my HP officejet
I "inherited" a 6210xi because BOTH hinges were broken... poor and weak
plastic design that breaks if the operator tries to raise the access
past about 40 degrees for access to ink cartridges... of course after
the hinges break it doesn't close properly to start again (except with
creative taping!). In my pursuit of these parts I found that the lower
hinge part (broken) Part#JB6100289A is actually a Samsung part for their
SCX-15 printer/scanner. It was also interesting to find several of
these 6210xi's for sale on eBay and other places for $10 or less as
"broken, parts only" and AMAZINGLY, it was the same broken hinge part
that put all of these out of service. Found the HP Part number as
RG5-6317-0000N but couldn't find anything except to buy either the Top
half of a whole 6210 or the Bottom half for hundreds of $$'s, far more
than the WHOLE new working item would be. UED.net listed the part as
"non-stocking" at $2.27 each, available Aug 8, 08, but it turned out to
be that they are negotiating for access to that parts and VIOLA! a few months later I received SIX hinges at $2.27 each plus shipping. You have to be creative to keep your old stuff working.
Can I get parts to replace broken hinge?
In the mean time, I kept my unit working by just removing the broken top half of the hinge.
You have to remove 5 screws using a TORX T10 screwdriver. First remove the small plate covering the back of hinge on the outside. Then remove the two vertical screws at the top of the hinge up under the hinge lip. Then open the cover (be careful to hold it in place so as not to damage the three flex connections between the lid and body) and remove the other two screws at the top of the hinge. Remove the broken top half of the hinge and lower the cover back down. Until you find a replacement hinge, you can put a piece of heavy duty tape on the back where the hinge was.
Vertical alignment
Usually this is asked when the printer is using more than one page of paper to print what the word processor shows as 1 page. This is fixed in the word processor program print set up module that opens when you click Print.
If you really want to change the vertical alignment of the print heads, then you need a different printer.
I NEED AN rg5-6317 0000N hinge
You can find these printers at yard sales, thrift stores and recycle locations, if you don't find one at any of these locations, check Ebay for parts or printers. I would not take it tp a repair location as these printers have some age and replacing them is a better option. Good Luck.
Not finding what you are looking for?