Top 20
GE Profile Over the RanMicrowave. Spacemaker XL 1800 1.8 cu. ft Questions & Answers
JVM1860WF001 - Was cooking soup
SOUNDS LIKE FLAME SENSOR SWITCH OPENED OR CLOSED AND THE UNIT THINKS IT OVERHEATED AND TURNED THE FAN ON TO COOL IT MUST FIND SHORTED FAN SWITCH
Microwave is Locked please advise on how to unlock.
Since I don't know the model, here's a general answer. On a GE over the range oven, the top air deflector assembly is usually removable. After its off, you will have access to the fasteners at the top of the control panel. Remove it, and you should be able to see the door switch/latch assembly on the left.
Do all of this with the oven unplugged. Do not go near the high voltage capacitor as it can retain a charge of 4000 volts indefinitely. Stay away from the rest of the h v wiring as well. If you need further help, I’m available over the phone at
https://www.6ya.com/expert/david_29ad5d1dd86564b0
JUST STOP WORKING NO POWER.
There is a fuse inside the unit you may check and see if that is it. If not then it will be the front panel. Hope this helps
Works but does not heat up
It may be damaged from inside. Check it to the Oven Specialist. He will assist you and told you that what's wrong.
Maybe its Power Problems that causing heat not to produce.
How can I check the diode?
It normally is not possible to check the diode of a Microwave oven without some special high voltage testing equipment. If you suspect it, replacing it would be much cheaper. A typical DVM will not do the job. But diodes usually are not the first part to fail; check the transformer.
Microwave turns on but will not operate
Probably best to have a repair tech look at it or just replace the microwave. You may have a problem either with the circuit board or with one of the door microswitches.
How do you safely remove a ge spacemaker microwave oven from its wall mount?
This is a two person job. You have to have one person holding it and the other takes the screws out from the cabinets above the unit. There should be two screws that are inside the cabinet that hold it up against the bottom of the cabinets. When those are loose you can slide the unit forward on the rails that attach to a large wall bracket. Or some use a lift type latch to the wall bracket.
Not finding what you are looking for?