20 Most Recent
GE Profile Over the RanMicrowave. Spacemaker XL 1800 1.8 cu. ft - Page 5 Questions & Answers
Pushed in spring loaded latch on the microwave. Need to pull it back out. Spring is not broke.
No, you don't have a new problem to fix, and consider yourself and anyone else that uses that microwave lucky.
Depending on where that crack is you need to know that the screen like structor in the door is actually a choke to stop and microwave energy from escaping, including anything around it. They are designed to stop any stray microwave energy from leaving the microwave. This could harm you so if it is anyware near that door choke, if I were you I would order another door. The same goes for the gasket around the inside of the door it to is a choke.
You are also causing yourself some potential danger because the door must never be circumvented to keep the light on or off because if you should accidently start the microwave then you will have problems.
The black dispay,
It sounds like you checked everything affordable. Going much deeper than that will be cheaper to just replace it. Microwaves are short life appliances, but they are also very affordable to replace. Make sure you checked all the micro switches- there should be I think 4 switches in the door. There is also a fuse on the circuit board. Good luck!
No heat in microwave even though everything else seems to work
The output of the high voltage section is 4000VAC (3000VDC) and can instantly lethal or can cause fatal defibrillation if contacted.
So unless you have the proper equipment and experience, i do not recommend measuring the high voltage.
<- With a full model number from the tag on or in the oven, I may have been able to give you specific help.
Without that essential information, I can only give more general advice.
I would ask for additional information, but FixYa no longer notifies us experts when such inquiries have been answered.
So you would need to post a new help request with the full model number from the tag, and symptom details - what it's doing or not doing, and when it happens.
Taking out battery
<- With a full model number from the tag on or in the oven, I may have been able to give you specific help.
Without that essential information, I can only give more general advice.
I would ask for additional information, but FixYa no longer notifies us experts when such inquiries have been answered.
If unplugging it for several seconds doesn't reset it, it may need minor circuit board repair, which I do on a regular basis.
Ge profile microwave just stopped working doesnt light up or turn on model pvm2070dmbb
You should first check the outlet with a toaster or hair dryer to be sure it's working under a load.
Then you should test the fuse then the TCOs.
There is a technical sheet hidden behind the grille or controls.
There is a video
here showing how to remove a typical over the range control panel assembly in under 5 minutes.
You can find helpful exploded view diagrams and order parts by entering your full model number from the tag on the oven
here.
You can download GE owner's manuals and installation instructions
here.
Control panel touchpad does not work; push buttons
follow this steps and fix it. God bless you
- Controller is confusedA
power surge or random non-reproducible action of the universe may have
resulted in the controller's program ending up in an infinite loop. Pull
the plug for a minute or two to reset it.
- Defective Interlock switchesThis can result in the controller thinking the door is open and ignoring you.
- CleaningCleaning
solutions (spray cleaner) may have gotten inside and shorted out the
touchpad or controller. If this happens remove the touchpad, let it air
dry for a few days, and then attach it back on the microwave.
Read more: http://www.appliancepartspros.com/repair-help/microwave-repair-help.html#4#ixzz2hVdoScpK
http://www.appliancepartspros.com
Not finding what you are looking for?