20 Most Recent Miele M625EG Convection Microwave Oven Questions & Answers

Remove the mains lead from the wall socket. Remove the cover, undo the screws holding the latch and replace.

First, I'm not a Miele tech. But I have worked on commercial espresso equipment and table top units. *** The following is for information only *** * I found this link that may help. Note that many of these table units require special tools to access. If your trying to access a panel with these special screws then removing them will probably void your warranty. Call your vendor or MFR for service. * follow the link for more information. Aloha, ukeboy57 https://www.bing.com/videos/search?q=miele+espresso+machine+repair&&view=detail&mid=CCE1F05D2886FF9F3826CCE1F05D2886FF9F3826&&FORM=VRDGAR

Broken microwave door See if this video will help

You cannot clean between the glass only on the outsides! If the obstruction is between the glass this will need replacing!

Impossible to say what the problem is but if the turntable has stopped you could check the turntable motor. This is easily accessed from the bottom of the unit but you have to actually break the sheet metal tabs that retain it in place and replace using the screws only.

If the owner's manual doesn't cover it and there's no obvious cover on the side or rear, you'll have to remove the outer wrapper.See these files:http://wwww.microwavedisplay.com/safety.txthttp://wwww.microwavedisplay.com/disassembly.txtOften on a unit whose bulb is not meant to be replaced by the customer, the light is located on the right side in the air duct attached to the magnetron or on the top of the oven cavity.Most bulbs can be matched up at hardware stores, home improvement centers, and places like Wal-Mart or even large grocery stores.

I have the same problem with my M625EG-ed from about the same period. My repairman said that it would be at least 300 € for a new unit. I opened it myself and cleaned the keypad with alcohol or aceton. It's not working perfect afterwards but it is better.
There's a fuse you have to take out when opening. Otherwise you can have problems with electricity (be carefull). The fuse I had, broke down and I had to buy a new one for 20 eurocents. Also watch out with the parts where the door closes. I had some problems with that too and now (after a few months), I had to buy a new connector part on the door (its the part of the door that closes the door and gives connection for the lights). This costed 12-13 € but I'm trying to install it now.
Andy Mahieu, Jabbeke Belgium

Most likely you have a shorted fan/light relay on the control circuit board.