20 Most Recent Frigidaire 30-Pint Dehumidifier - White FAD301NUD - Page 4 Questions & Answers

fad504dwd19 not shown as a recall

Hello Paul, thank you for your post! From my understanding you need help changing the filter on your Frigidaire dehumidifier. I have located a copy of the manual and on page nine it will provide you with proper instructions on how to remove the filter. Best of luck! -Matt ftp://ftp.electrolux-na.com/ProdInfo_PDF/Edison/66129917125en.pdf

Hi Walter, thank you for your inquiry. I understand that your Frigidaire Dehumidifier is tripping the breaker. I would recommend checking to make sure that the bucket is installed properly. If everything checks out I would possibly changing the fuse in your home circuit breaker and never use an extension cord. Hope this helps! -JK

probably the ac section to cool the humidifier is not working for a de-humidifer to work there has to be a cold surface to condense the water vapour in the air if there is no ac unit ,it will still need that temperature difference to work or a sufficient humidity in the air to work

Thank you for your post, K!

I understand that your Frigidaire dehumidifier is continuously running and it is not collecting water. This can be caused by a dirty filter. A dirty filter can restrict air flow which will allow your dehumidifier to not pull in air. I would recommend checking your filter to make sure it is clean.

Frost on the coils within your dehumidifier will also cause your dehumidifier to stop working as well. You should check to make sure that there is not frost visible on your dehumidifier. If you do locate frost you would need to perform a manual defrost on your dehumidifier and you can do that by disconnecting power from it for at least two to three hours.

If these steps do not resolve your issue you may need to reach out to the manufacturer for a proper resolution. I hope this information is helpful to you. -Matt

Good Morning Mark, thank you for your post!

I see that your Frigidaire dehumidifier is displaying an error code of "ES" and you would like to the meaning of that error code. The "ES" error code stands for evaporator thermistor error. This could be a possible problem with your control panel, thermistor, or a wiring harness. I would recommend contacting your manufacturer for further assistance with your dehumidifier. Best of luck! -Matt

Thank you for your inquiry, friend!

I see that you have a Frigidaire dehumidifier and the green power light stays on except it is not working. Typically, you have to set the dehumidifier in order to operate. What does your display say? If you can provide me with any additional information I would be happy to assist you. -Matt

I appreciate your inquiry, friend!

I see that you are having a complication with your Frigidaire dehumidifier going back to 30% after setting it. This could be a possible issue with your sensor or control panel. I would recommend performing a reset and you can do that by unplugging the power cord for roughly ten minutes. Are you currently in warranty? I would suggest contacting your manufacturer to see if there is any additional coverage on your dehumidifier. Best of luck! -Matt

Thank you for your inquiry, friend!

From what you have described you would like to use your Frigidaire dehumidifier for a heater. Unfortunately you are unable to use your dehumidifier as a heater. You dehumidifier will pull air from the room and distribute the same air. I would not recommend performing any alterations on your dehumidifier as that can void any warranty. Hopefully this is helpful. -Matt

Good Morning friend, thank you for your inquiry! I see that you are having trouble with your Frigidaire dehumidifier displaying an error code of "F2". Typically, an "F2" error code stands for a miscommunication error. This could be a possible problem with a sensor or control panel. I would suggest performing a reset and that can be completed by disconnecting the power from your dehumidifier for roughly ten minutes. If you are still under warranty I would recommend contacting your manufacturer to see if any additional assistance can be provided. Hopefully this is helpful. -Matt

Hello Winl, thank you for your inquiry!

I see that you are having issues with your clean filter light coming on in your Frigidaire dehumidifier. From what you are describing it sounds like a possible issue with a sensor within your dehumidifier. I would recommend consulting with your manufacturer to see if they can provide any additional assistance towards a resolution. Best of luck! -OOS