20 Most Recent Canon PIXMA iP4000 InkJet Photo Printer - Page 3 Questions & Answers

hello this error means that the EEPROM data of the print head is faulty so is a problem with the print head, Install the print head properly,and close the access cover. Or, with the print head installed, turn the printer off and on, i hope it will help And please check the below link to get the service manual for ip4000 it will be helpful:http://goo.gl/EdjmhGood luck.

remove print head assembly. clean off.
print head not on cartridge. 

The Canon PIXMA iP4000 InkJet Printer has two paper sources for printing. Likely the top feeder tray is not completely closed (it is possible you do not have the printer set up to feed from both which may cause the error).See the Quick Start Guide and the Picture Below:

Go to this site:

IP1200 Support

Select your Operating System and language from the drop-down menus and click "Submit".

The available software (driver and other) will be listed for download.

Thanks for using Fixya.

The Canon PIXMA iP4000 has a RESUME/CANCEL button which allows you to resume a print job after an error has been fixed or cancel a print job altogether.You can find the manual here: http://www.usa.canon.com/cusa/support/consumer/printers_multifunction/pixma_ip_series/pixma_ip4000#BrochuresAndManuals

Carefully take out the ink cartridge from the printer. Make sure that you unplugged the printer. Do not touch any electrical wiring. Attach the new ink cartridge. A distinct click will confirm that you reinstalled it properly. Do not expose the cartridge to heat or light for more than 10 minutes to prevent damage. And run a test print.

DId you use a refilled or 3rd party cartridge?

Try a new cartridge

http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&fcategoryid=184&modelid=10239#DownloadDetailAct

here u can find the driver..

What version of Win 7 are you using? and is it the 64bit or 32bit version? Once you know this info go to:http://driverscollection.com/?H=PIXMA%20iP4000&By=Canonand download the correct/newest drivers. Good luck.

Try unplugging leads blowing the end then leave without power for 5 mins then try again

You may, it depends upon the contest conditions. You need to read the fine print.

hi sir send my smartmovie license key for 355718024819300

maybe the ink is getting low or your settings are too low for a quality print. if these are not the problems see owners manual.

I found this website http://videomakingservice.com and it will show you the flashing lights on your canon camera mean. You might just need to recharge the battery