20 Most Recent
Honda Ex-800 Portable Gasoline Generator 800 Watt Output, Old Stock Ex - Page 7 Questions & Answers
O-ring size for bostitch sb-1850bn trigger unit
Hi,
if this data is not in any of the documents that came with the nailer kit product, please work with one of Bostitch vendor partners for the product in order to acquire the ring size information. Some of these vendor partners would be Lowe's and Walmart. You can call ahead before attempting to visit each partner.
Thank you.
How to check and maintain oil for CP 0200608 coleman powermate 6 gallon
on the compressor end is a plug that when removed is is oil level dipstick. you will need to ad 30 weigh non detergent oil until level is correct by measuring with dip stick. do not overfill, if you do you will need to empty by tipping compressor of on it side.. where did smoke come from . did it smell like oil burning or electrical.
My titan 400I won't prime what can be wrong with it?
OK, Just solved this problem with my Titan 400 not priming....After searching the internet I got the clue that it was the inlet ball valve being stuck. Most said it was from leaving paint in the system or poor cleaning habits. I thought "Not me, I always do a good job cleaning the sprayer and leaving pump preserver in the system when storing". But I was wrong. After disassembling the inlet valve housing (shown in the manual) I found the valve ball stuck to the seat. After freeing the ball there was tiny bit of paint on the seat but it was enough to prevent it from functioning. Reassembled and it works fine. So maybe just luck of the draw. I don't use the system too often and it had been 6 months since the last use...still I stored it with line full of pump preservative. Symptoms were that when in prime it would not **** from the siphon tube (supply) but motor ran fine. A bit painful fix but not terrible, exercise cost me an hour, but next time would take maybe 15 minutes to correct. Hope this helps.
Not getting any air pressure
Larry when you turn your compressor on do you any sounds? I need a little more info I want to help I just need the information Good Luck Mike L
My sullair 185 will not idle down
Hi,
Please attempt to disengage the clutch of the compressor while simultaneously lowering the engine speed.
If this doesn't work, please call Suilar at 1-219-879-5451.
Thank you.
Not finding what you are looking for?