20 Most Recent
Lexmark E232 Laser Printer - Page 9 Questions & Answers
Paper jams no matter what stock I use; Lexmark e232
Slipping paper feed rollers is probably causing the jamming. Remove the paper tray and tip the machine back so that you can access the feed rollers from underneath. A good technique to isolate this problem is to remove the rubber feed tires, turn them inside-out and refit them. If it now works OK you need to get new feed rollers.
I have a Lexmark E232 LaserJet printer that
An isolated print job may be so intensive that it consume all of the memory available on the printer but that would have to be a seriously intensive print job.
Once that job is flushed from the printer, following jobs should be fine.
However, if you have a block of memory failing, you may have to replace the memory chip.
You could print the printer's menu settings and see how much memory is installed in the printer.
Don
Lexmark E232 Load Paper
see my other solution, glue a bluetack on the rubber rollers, you will need to do that occasionally.
PAPER JAM
The problem sounds like your rollers have lost their grip. Remove the paper tray and tip the printer up. Push the red lever on the left of the printer down and you will see the feed mechanism with two wheels. Remove the rubbers on the wheels and turn them inside out. Replace them on the wheels with the worn side now inside and the 'sticky" side out. You should get at least another couple of years worth of use before you need to replace them.
The only light on is the error light
Hi,
U need to check if the printer is still having any paper inside. Check gears and rollers if there is any Jam. Try to uninstall and reinstall the printer. And try using calibration option included with the software.
PAPER JAM
Rotate tires. Pull out paper tray. Pull down on red low paper indicator at left bottom. Two rollers come down on axel near center. I pulled off the rubber tire like roller, then twisted the roller inside out and reinstalled it with the fresh side out.
If tires dry out again will probably buy new ones from ebay.
Does not load
Do you hear the Paper clutches activate in other words do you hear the printer trying to pick up the paper, if so then your clucthes are working but, your paper feed tire could be worn, have a tech replace this. If you don't hear this then it's could be the selonoid not activate which means the soleniod or the board.
Printer not printing
If "ready" and "toner low" lights are both on, your problem is probably photoconductor. You must reset your printer. Turn on the printer, open front door and press "cancel" button until all lights cycle on the operator panel, than release it and close front door.
Lexmark E232
oh my GOD ,PLESE OPEN ITS ELECTRONIC BOARD AND REINSTALL IT PROPERLY
Lexmark E232 photoconductor
Make sure to install the new photoconductor 1st.
1) Power off the printer using the switch in the back.
2) Open the front cover.
3) Press and hold the Continue button (Big silver button with Diamond shape symbol) and power the printer On (turn the switch back to ON).
4) When you see the last light i.e. error light on solid, release the Continue button and close the front cover.
5) When you close the cover you will see all the top 3 lights on solid.
6) Press the cancel button with X symbol for 4 times very slowly till you see toner low light (i.e. second light from top) on solid.
7) Press the continue button and wait until you see the light sequence.
8) Press the cancel button and wait until you see the light sequence.
9) Finally power off the printer using the switch in the back (IMPORTANT= wait 1 minute) and power it back on to exit the configuration mode.
Not finding what you are looking for?
