20 Most Recent
Ricoh Aficio 2022 All-In-One Laser Printer - Page 6 Questions & Answers
SC548 AND SC990
Sc548 can generally only be reset by entering service mode, and generally is caused by a defective thermistor (thermostat) in the fuser, and/ or power fluctuations. Sc990 is a software issue. I'd consider a new HDD> You'll need a tech for these problems.
What does 'SC726 Problem with
sc726 is a finisher lift motor error. The lift motor could be bad, or the sensor that detects where the motor is might be bad. It could also be an overload problem, if something is in the way preventing the shift tray from lifting.
Error code sc 542?
1. Press Yellow Botton.
2. Dial 107
3. Pess and Hold Orange Botton until you hear noise.
4. Press COPY SP
5. Turn off and then Turn on the machine.
Good Luck
Lanier 5622, "WAIT" apear and
When the machine stays at the "Please Wait" message and nothing else happens, the most likely cause is the hard drive. The hard drive will need to be replaced in order to restore full functionality. You can disconnect the hard drive to make the machine work in the meantime, but you'll lose some functionality.
PROBLEMAS CON LA COPIADORA
hello . sorry but your problem is the laser polyigon is defective. u need to change it. i`m an ricoh technician. sorry
We have lost the sharpness/ clearness on the
I know this may be a stupid question but have you tried adjusting the screen contrast wheel on the left side of the panel? Sometimes they get bumped and this makes the screen go nearly blank. It is either that or you have lost the flourecent diplay tube which lights the screen.
I have a Ricoh copier
Unstable fusing temperature
Symptom:
The fusing temperature varies 50°C or
more within 1 second twice
continuously.
Possible Cause:
• Thermistor defective
• Poor connection of the fusing unit
• Power supply unit defective
Functional problem sc 541 for
SC541 = The
melting temperature measured by thermistor is less than 71 C
The problem lies in the fuser:
- Thermistor
fuser defective or incorrectly installed
- Fuser Lamp
failure
Solution: Replace Fuser
Not finding what you are looking for?