20 Most Recent Life Fitness 95xi Elliptical Crosstrainer Questions & Answers

Battery is obvious first check. Using a multimeter on 20V DC setting, touch both + and - terminals and not should be very close to 6V. In my case, my battery was 2V but after replacing it, still wouldn't power on. I did notice by main wiring harness from control board to the display was warm, so I repacked the control board and voila! I probably static shocked the control board when i was moving it. See here: https://www.fixya.com/support/t25141832-lifefitness_95xi_wont_turn

Check the speed sensor to turn on the elliptical, or send the lower board to repair with www.xtremefitnessservice.com, ask for Javier

Dear Sir:You can have some pencil, and with the point of the pencil, go under the display board, in the small orifice, and with the point of the pencil press the small button, and ready. Restart the machine.sincerely. God bless you

I hope this helps

The battery is located in the front of the rear drive mechanism. It is mounted just below the alternator control board. The following video shows the battery location along with the battery replacement procedure. Battery 6 Volt 2 5 Amp Hr LifeFitness 0017 00003 0685 SPORTSMITH net

No, but it does have a load resistor. Resistor Bracket Assembly 9500 GK61 00002 0044 SPORTSMITH net

I would suggest verifying 6 volts output from the battery. From there, check the reed switch connection on the power control board. Also verify the gap between the reed switch and the magnet on the pulley. It needs to be close enough to the magnet to get a good reading. I am attaching a link to a video that shows the reed switch replacement procedure. You can see the magnet and also the slots in the reed switch that allow the adjustment. LifeFitness 95Xi Crosstrainer Video Reed Switch Replacement Speed Sensor

in rear cover 4 screws 2 each side and allen key to remove battery

under main shroud 4 screws 2 each side, then allen key to remove and replace.

please see the video and execute. God bless you

How do I fix error 6 on my treadmill? E6 Error: Controller malfunction. Resolution: Ensure that the cables connecting the console and the controller are secure. If any of the cables/connectors appear loose, completely power off and unplug the treadmill before unplugging and reattaching the cables.Sep 23, 2021

E6 Error Code: Control Board Malfunction - Spirit Fitness Support

https://www.google.com/search?q=LIFE+FITNESS+T3+ERROR ..