Tilia FoodSaver V2840 Advanced Design Vacuum Food Sealer - Answered Questions & Fixed issues
Foodsaver V3250 manual
Where can I get a manual for the FoodSaver V3250? Mine is new and it did not have one in it???
Thank You!
Sherri
Foodsaver v485 no longer seals
Hi tami prevostYour vacuum pump seals are wearing and not allowing the vacuum build up as it was new...Look at the manual that came with it and see it you can order parts for your vacuum foodsaver, if you can order the seals/orings,etc that is needed to repair the vacuum part of the machine.Please take time to rate meBud
10/12/2012 9:30:46 PM •
Tilia Kitchen...
•
Answered
on Oct 12, 2012
•
1,337 views
Tillia Foodsaver VAC 370 won't stop vaccuming to seal
My Foodsaver 820 wouldn't stop vacuuming, and after fiddling with it and doing a little research, I located the vacuum switch on the circuit board and de-soldered it (verry simple, only 2 solder points). On the underside of the switch it looks kind of like an allen head screw. NOTE before attempting this, make note of how far the screw is recessed into the housing and/or count how may turns it takes to remove it! I removed the screw and spring and sprayed electrical contact cleaner in the holes and in the hole where there is a little brass disc. (Wear safety goggles for this) The little brass disc is what makes the contacts that turn the pump off after reaching the necessary vacuum. Mine was gummed up and stuck so it would never make contact to shut off. I reassembled it, and re-soldered it back on the board. I then put the whole thing back together and it works like new.
You could probably make the same repair without removing the piece from the board since there is a hole in the circuit board where you can gain access to the screw, but it will be messy. If you have any experience with soldering, it is about as simple as it gets
10/13/2011 3:38:44 AM •
Tilia Kitchen...
•
Answered
on Oct 13, 2011
•
6,171 views
I have a v2490 model that just keeps running &
This is typically a bad seal and the vacuum cant build enough pressure. You can usually dampen the black rubber seal with a sponge and water before you use the machine. this solves the problem most of the time.
Maplin N20FR - damp test meter. I have no
N20FR - Used to measure the moisture level in sawn timber (also cardboard, paper) 6 to 44% on the left hand scale and hardened materials (plaster, concrete and mortar) 0.2 to 2.0% on the right hand scale
4/14/2024 9:12:34 PM •
Kitchen...
•
Answered
on Apr 14, 2024
•
2,199 views
Not finding what you are looking for?