20 Most Recent
Husqvarna 128 LD Weedeater - Page 6 Questions & Answers
Loud pop when started in free wheel mode on accident
That is a good question. It could have been a spark plug. Have someone look at it for you. A fuse that goes bad will not make a noise or a give out a bright light. It could have been a backfire from the exhaust. Will it start? If so, then it was not the spark plug.
Why do my husqvarna chainsaw lose compression?
What model chainsaw is it? The most common reason is not enough oil in the engine. Oil lubricates but it also has a cooling effect as well. Is your chainsaw 2 stroke or 4 stroke. A 2 stroke engine needs a measured amount of two stroke oil added to the fuel to prevent problems like this.
A 2 stroke will run without the oil in the fuel but it damages the engine if only used that way.
Why doesn't my husqvarna 350 chainsaw not start?
Have you checked the keyway that is molded in to the aluminum flywheel if there's even a little tiny chip and it Will throw timing off enough that it won't fire at the right time I'm not an expert I had similar machine do the same thing didn't look like there was anything wrong with the key way in the flywheel just glancing at it but there was a small chip out of the side very hard to see keyway is very small
BOLT THAT HOLDS BAR ON FELL INSIDE CASE OF MODEL
willie ,you are not kidding,just not explaining very well.there is no way a bolt from the chain bar could fall into the crank case. If you mean the outer casing of the whole chainsaw ,that is ok all you need to do is remove the outer case as if you were going to fit a new chain and it wll probably fall out if it has gone the other side take the recoil start off and it will then let me know please
Question about a very hard to start Husqvarna 455--can anything be done?
There is a good video on that saw being disassembled. IT is worthy to note that hard to start may be due to fuel or ignition issues. Ignition issue could be the timing on the flywheel which is keyed to the shaft and also the gap between the magneto coil and the magnet. This gap is crucial to the output of the spark wire. It does not look like an easy saw to work on https://www.bing.com/videos/search?q=husqvarna+455+rancher+parts&docid=608051851890751573&mid=F9526C9C2FA8331F27E2F9526C9C2FA8331F27E2&view=detail&FORM=VIRE Also being a straight gasoline engine it is going to have more resistance to starting due to the compression stroke of a 4 cycle engine.
Not finding what you are looking for?