20 Most Recent
Husqvarna 128 LD Weedeater - Page 2 Questions & Answers
Runs a few seconds then dies, new gas lines new
Bill it sounds like you havn\'t put the carb back together properly. The gaskets need to be done correctly for the engine to suck fuel through. It runs due to limited amount of fuel getting through.
Remove head
Enter a 6mm pin throught the top of the gearbob ( there is a hole in the housing to take it ) turn the trimmer head so asthe pin enters the driver flange below and locks it, now grab the complete trimmer head and turn clockwise ( left hand thread ) the trimmer head will unscrew from the output shaft and come away.
Weed eater bogs out at full throttle
Make sure fuel is mixed correctly, make sure the choke isnt stuck on aswel, ive had it happen to me before when the little blue leaver sticks and it wont rev out properly.
I tried pull the cord stuck took it apart spring ok.the shaft from engine stuck,
Sounds like you have a bearing failure, eithe big end or crank shaft bearing. When they go they quite often knacker the piston and cylinder too as it can put them off square. Remove cylinder and the problem will be easy to locate as you can see the big/small end bearings and check for cylinder damage. Often the cost of repair far outweighs the value of the equipment.
Detachable shafts will not go on.
check flex shaft,inner part of the larger housing,be sure the end is not damaged.....also check flex shaft end from the engine side,may have damged coupler
Stringing a husqvarna weedeater
The 125LD had a T25 bump feed trimmer head, depress with finger and thumb the tabs either side of the head, the base will then pull away with the white centre spool, take a lenght of 2mm cord, bend in the middle so as you have two equal lengths, hook the bent end into the cut a way in the spool and wind both lengths in the same direction as indicated on the spool, once you have enough cord on the spool secure the ends in the slots on the outer edge of the spool to stop it all un raviling, place the spool back into the spool housing, carefully place the cord through the metal eyelets, push the assembly back into the upper housing clicking it back into position.
Not finding what you are looking for?