20 Most Recent Belkin N600 DB Wireless Dual Band N Router - Page 6 Questions & Answers

Have you gotten the latest driver for the Belkin? How far is the Belkin from the router. Use the cable and base with the Belkin and put it as close to the ceiling as you can. If the router is on the floor or on the desk, relocate it to a higher location.

Does the surge protector have a "in and out" phone socket? Plug everything into the "out" side and then run a "phone wire" from the "in" side into the wall socket,.. you should be protected.. You are putting "all your stuff" after the surge protector.. so the surge protector can do its job..

Try opening the Network Control Panel on the MacBook. Select the TCP/IP tab, then click Advanced. Note the list of IP address numbers. Click the "Renew DHCP Lease" button and see what changed. Most likely all of them did, in particular the "Internet Gateway" and "DNS server" addresses. The first is the connection between the D-Link router and your ISP, and the other addresses are for servers that translate your web browser URLs into the IP addresses for the web sites you want to see. The Gateway and DNS server addresses have to match those in the upstream router(s). The routers must have current IP addresses assigned by the routers upstream, and any client computer must have a current address assigned by the first route upstream. You can check into this by logging in to the webpages for your routers and examining the status reports. Apparently one of the devices in the chain fails to obtain a new IP address when the D-Link router is powered on. I suspect it is the Belkin router. A computer with an expired DHCP lease will probably be using the Internet gateway IP address assigned to the D-Link router when it was on before (in a busy neighborhood, that address would have been re-assigned to some other household). The Windows system may be sending a request for DHCP renewal up the line, which triggers the Belkin router to ask for the same from the D-Link unit, but it may be ignoring the signal from the MacBook or not getting one. If the MacBook successfully gets online with a manual Renew DHCP Lease request, obtain the owner's manual for your Belkin router (find the model number, then go to the Belkin support/downloads page for that model). See what settings are available to automate the DHCP renewal process.

Please check the Network Range B/G/N Signal. This could be the issue if other aplications are able to connect. Also try to delete Wifi Profiles using the USB and add fresh wifi networks If not in install & reinstall the the USB Software on ur pc / laptop Lastly if this doesnt work try to use the USB Adapter on another network / other device and try to connect If it doesnt then u have a USB Issue Cheers Eddie

Review this link I hope this will fix the issue link:http://www.keypostings.com/2017/04/25/set-up-vpn-belkin-router/

Hello,

The person that configure your router must have put a security key during the process of configuring your dell laptop with your router, that is why the internet explorer of the toshiba is demanding for a network security key.

Do you type in any security key while using the dell laptop? if you do, then it is the same key, you will enter on the toshiba to pass through the router because the security key is on the router.

Also If you can contact the person the person that configure the router, he should be able to tell you what the security key is.

take care.