20 Most Recent Brother DCPJ125 All-In-One Inkjet Printer - Page 8 Questions & Answers

REPLACE MAINTENANCE UNIT

Check the ventilation fan (not working)

Usually from the maintenance unit, chabge it.

The scanner type mounted doesn't match the eeprom data. Refer to qualified technician at Brother service centre for checking

Probably the laser unit is faulty

The waste ink tank is full, replace it.

Which bearing ?

Replace the high voltage PCB or the main board.

Check the ventilation fan on the side. Might not be working. Remove any foreign material blocking the fan.

'unable to print 73' is a Printhead error.. Usually the printhead is an expensive part around $80 to $110, and you will need a full set of cartridges to prime the new printhead.. Sorry to say that this repair is not normally economical to go ahead with.

A picture of the printout is required to confirm, nevertheless, it could be toner. Printing does not use scanner, so it has nothing to do with the scanner.

Ghosting on machines can be one of several causes.

1. Poor Quality/ Damp toner - Replace the toner cartridge
2. Worn Drum Unit - Replace the Drum Unit
3. Fuser Unit Failing - Replace the Fuser Unit (Normally more than the printer is worth).
4. Damp Paper - Open a new ream of paper and try printing again (This is the cheapest option to start with diagnosis).

Magenta Print-head may be blocked. Depending on the model of machine. Either on the Menu on the printer find Ink Management or press the Ink Management button. Print a Test Page If no Magenta Dots showing then proceed to Cleaning and Clean the print-heads through the proceedures given on the machine. Print another test page. If Magenta Dots are fine then cleaning done. if not then try cleaning again. If still not fine then the machine will need to be cleaned professionally which will cost a reasonable amount. Most service fees are more that it is to replace the printer.

Pull out the paper tray. Lift the cover of the tray. Slide paper into the tray. Close the cover of the tray. Push the tray back into the machine till it clicks into place.

This machine uses a Reset Gear to instruct the printer it has a new cartridge. The Starter Cartridge that comes with the machine does not have this gear attached to it so refilling the cartridge without installing and resetting the gear will not allow you to print normally. If you are using a store bought cartridge that you have since refilled you can reset the gear to tell the printer it is a new cartridge.

Go to the Brother Website for your region. Find the Downloads section. Put in the details of your machine and search for the appropriate downloads for your machine. Download the Drivers, Manual etc from there. Some of the regions may even offer to sell you a CD with all the downloads on it. But just download what you need.

windows make loads of hardware errors, if it is not being picked up by the computer but the printer is turning on check it has not been installed as with the same name but a number after, if so select that for printing if not try plugging the usb lead from the printer in to a different socket on the PC. hope that helps ma

You can get third party software in order to avail the facility to combine pdf to a single file