20 Most Recent Xerox Phaser 8550DP Printer - Page 6 Questions & Answers

Hi Julian, You just got to look hard at where your paper jammed. Don't just rip out the page. investigate fully I'm sure the answer must be obvious. Good luck.

Hi Ydn2, You need to say what type of machine, what colour, what conditions. etc,etc. Good luck.

The Print head assembly is not able to move to its home position probably some debris could be stopping it from moving to home position check and clean as necessary

19.003:48 is the error code 21274 is the number of pages the unit has printed. the error indicates a power difference of +- 20% when trying to drive the printhead. The issue is the Electronics Module (System logic and power) or the Wave Amplifier (Printhead Controller). Both of the parts are fairly easy to replace. If it is the wave amp it is a somewhat affordable part.if it is the EM you should replace the printer. It isn't worth the fix.

Hi Anonymous, I suspect you must have solved this one by now. I can only assume you have something jamed inside. (your thoughts too I expect) I would have thought removing as many panels as you could to gain access to the drawer unit to add paper might reveal where the problem might be! Good Luck.

Hi Anonymous, I suspect you should have this problem sorted by now. Looking at the Xerox website says that a replacement printer is available for around £190 that could have worked out cheaper that trying to get this one repaired. Replacement Xerox 6500 Good Luck.

It's referring to a particular sensor I suspect. More investigation needed. Good Luck.

This is usually the print heads are not working correctly. Either purge forever and the problem might go away, or call in Xerox. Good Luck.

Sorry, Anonymous can't help you with that one! Good Luck.

go into printer properties ( in the computer printer section and find the tray tab adjust to what you want , apply and save

Laser printers in general are not extremely good at photos. You may be able to increase the contact sheet picture size. If you've not already set "best quality" mode, try that.