Top 20 Zebra 105SL Thermal Label Printer Questions & Answers

Type the IP address of the printer in your web browser. If that is not working verify that you can ping the printer.

Drivers have an entry in preferences/page setup where you can rotate the data on the page. Look for 'Oreintation' settings or 'Layout Settings' called 'Portrait' & 'Landscape'. Also the software being used to send the data will have settings in it to rotate the data, most likely. Look for Options or Edit in the software and see if there are any settings for rotate." Feel free to call us at 972-535-5555 for more help. www.emsbarcode.com Inventory Management Solutions By EMS Barcode

Hello there, You normally configure a label size from 2 places: a) Printer Driver(I reccomend downloading the one from Zebra from www.nicelabel.cl) b) Directly from Printing software option In both cases, search for the "Genera"l tab and you will be able to configure the label size

the flag inside the printer was moved out from sensor, you will have to adjust and tied the screw a litl bit as well.

There are 3 different DPI Printheads for Zebra printers if you print a label set up for a 200 DPI Printhead on a printer with a 300 DPI Printhead installed it will be about 66% of the size.

halp left or half right? Try driver from www.seagullscientific.cam driver, it will help to reset to factory default., turn off and on, do the pause test and if still doing that, printhead need to be replaced.

1234 or 9999

Check the ribbon sensor and ensure there are not any debris stuck to / around it. Clean with highest Ispropyl Alcohol available. Load a genuine Zebra ribbon and see if error is resolved. If none of that works, turn it off, unplug it from power, turn it on while unplugged. plug it back in and turn it back on and see if the error returns.

Sounds like it may need a calibration. Press the calibration button on the front of the machine.

You can either see my simple Tool with 3-easy Steps to create a barcode label!What kind of barcode symbology do you want to use?

Please post an image

Are you using any labeling software or zpl programming?

replace the memory car

This sounds like a mismatch between the printer settings in the print driver and the label settings in your label design software. In the printer driver - printer preferences- set the physical label dimentions.Also set the printing defaults to the same settings.In you design program ensure your label size is the same as the printer driver and also you can set the print preferences in the same program, ensure they all match and hey presto it works. But if nt then contact www,lancerlabels.co.uk, they will talk you through the problem on the phone. They will not charge for the advice.

First Step: Do a configuration print on both units. If you encounter differences, correct it and/or do a hardware reset on both unit.Second Step: Give it a try. If there are still differences ...Third Step: Save the "print data" in a file -> you can do it in the drivers option. Then do again a hardware reset and take the file and send it to the printer (you have to get the same printout with this methode!). If yes you can search backwards ...

HiTry calibrating the printer.Click on the link below for a video tutorial on the same.www.racoindustries.com/zebra-105sl-printer-calibration-video.htmHope it helps.

Not a question.

I have this issue whenever I set my default printer to a label printer. Use the other printer as the default and set to the zebra only when you need it.

This may be due to the fact that your ribbon is too translucid, back quality transfer films.
To overcome this you must use a bit of scotch and a piece of film and stick it on the ribbon sensor.
Else try a callibate to see if the error is not solved