Audiovox AVD300T Car DVD Player - Answered Questions & Fixed issues
Curtis DVD8723UK: Wrong Region problem
Try this:
Turn the player on.
- Press and hold Clear until the screen turns dark.
- Now enter a region code (0 is defult, or 1 - 8).
- Press and hold Clear. The opening screen comes back.
- The default code (Region 0) is reset when the unit is turned off.
It seems (and this should be verified on more players) that if you enter the number 13 instead of the zone, it makes the player multizone permanently.
Playing video audio through car stereo Toyota Matrix
You're probably gonna need a wired FM modulator. That part will take an audio output and run it into your antenna plug on your radio. It will use a FM channel, but it's wired directly to your stereo. So no static as found with wireless FM transmitters.
NO AUDIO
Tune radio on 88.7 fm an will transmite the dvd audio.
SAYS NO DISC
Try playing commercial DVD instead of DVD+R or DVD-R.
What are the input wires on a audiovox amp777
The Audiovox AMP777 is a 4-channel power amplifier, and the input wires will depend on the audio source you are using. Typically, the amplifier will have RCA input jacks for left and right channels, and you would use RCA cables to connect the audio source to the amplifier. Some amplifiers also have a high-level input option, which would allow you to connect speaker wires directly to the amplifier's input terminals. However, it's always best to consult the user manual or contact Audiovox support for specific wiring instructions for your amplifier model.
2/24/2023 9:29:26 PM •
Audiovox Car...
•
Answered
on Feb 24, 2023
•
61 views
My cd runs but will not play the cd
Quite common problem. Repair it or replace your player if repair cost is too high. Personally, I stopped using CD players time ago: I use a mp3 player.
5/13/2015 3:23:03 PM •
Audiovox Car...
•
Answered
on May 13, 2015
•
238 views
Red light is on and subs won't play
sounds like the amp is in protection mode. try disconnecting the subs and see it the light changes to green. if it does then the subs are your problem. if the light was allways red while it was working then the subs may be disconnected inside the box or have gone bad. try using a diffrent speaker and connect to the amp.
12/18/2014 2:55:53 PM •
Audiovox Car...
•
Answered
on Dec 18, 2014
•
231 views
My dual dvd player starts the movie over after i go over a bump
Bring it back to where you bought it and buy a better name. There may be a firmware update available for the unit which improves it's behavior and recovery. If you're not able to return it, perhaps you can isolate it from bumps by placing it on a piece of foam. I'm sure it may be very frustrating.
12/14/2013 4:55:00 AM •
Audiovox Car...
•
Answered
on Dec 14, 2013
•
54 views
Not finding what you are looking for?