Top 20 Kenwood KDC-MP228 CD Player Questions & Answers

1 check fuses for the power and the permanent live also check car fuses

Here is a link to the manual for this Kenwood deck. http://manual.kenwood.com/files/B64-3898-00_00_KW.pdf

sounds like a short or a issue with you head unit. did you install it your self or get a company to do it?

use this link http://www.kenwoodusa.com/UserFiles/File/Global/Consumer/Manuals/KDCX569.pdf or http://www.nodevice.com/user_manual/kenwood/car_electronics/KDC-MPV622.html#.U4cySSjwrgE hope this helps

Sounds like you crossed wires. Civic or should say Hondas wiring is different from most cars color codes check the wires.

no many codes

Hit the INSTRUCTION MANUAL if you don't have it, HERE IT IS :http://manual.kenwood.com/files/B64-2926-10.pdf

normally negative. You can check by cutting the wires leaving them connected to the speaker and touching the wires to a nine volt battery. if you connect the negative terminal of the battery to the black/stripe wire and the positive to the other wire the speaker will either push out or pull in. if it pushes out then the battery will tell you the positive wire. if it pulls in the polarity is reversed and you need to reverse the wires. do not send the battery voltage back up to the headunit you will blow a channel in the radio. I’m happy to help further over the phone at https://www.6ya.com/expert/chris_7f7f91eb941fb23f

by taking out the car battery the way you did, the radio thinks that it was stolen & placed into another car. You have to go the KENWOOD people.

Visit the new website siriusxm.com then turn on your radio and put it to channel zero get the radio id which compose of an alphanumeric characters. Then on the website refresh.siriusxm.com enter the radio id of your radio and then put your radio channel to channel 1 the go back again to the website after inputting the radio id click refresh after 5 to 15 minutes turn on to the channels that you want. Make sure that your car antenna is facing under a clear view sky.

Hello,

Error 68 means it is trying to connect to a bluetooth enabled cell phone. You should turn off the blue tooth pairing options under the radio options. Go through the menu and you should find it.

I hope this helps

you may need to press the seek up button once the code is entered.

The output ic is a TDA7560A. You can get it at pacparts.com.

Radio code is specific for each and every car. It is specific like anti theft code. You can get it by providing your VIN# and registration details in authorized dealership. Nobody else can provide you. If anybody can provide you that , then there is no meaning of security for your car.

If you need to remove the head unit, have a look at the removal guides at www.carheadunit.co.uk

no, you need a remote in order to reset it.

Double check your speaker connections. Make sure + goes to plus and - to minus (phase) and make sure all are grounded properly. Is there an amp possibly in line? If so, make sure connections are good there also make sure powered up (it happens to all of us)

the code the dealership gave you was probably for the original radio in the vehicle. the kenwood radio is not stock.

The following diagram will help you out.

try going into the menu and see if you may have aux turned off.