20 Most Recent
Campbell Hausfeld Husky Gravity Feed HVLP Spray Gun, HDS79000AV - Page 2 Questions & Answers
Campbell Hausfeld workhorse 3.5 stops after it gets hot and only hums when you try to restart. After sometime left turned off will restart but does the same thing
This fault indicates that there is too much back pressure on the pump causing the motor to strain. There is a check valve located at the tank that prevents pressurized air from returning to the compressor. Here is how to test for leaking check valve. With no air in the tank, run the compressor till you reach about 40psi and shut off the unit. Listen or air leaking out of the air filter or the pressure switch. Leaking air indicates bad check valve. If no leak, allow the compressor to reach fail condition, then unplug the compressor and immediately let out all the air and see if the compressor restarts easily. If the compressor will not restart with no air in the tank then may have failing capacitor (s). Easy to replace. ;Good luck with your repair.
9/5/2018 2:26:28 PM •
Campbell...
•
Answered
on Sep 05, 2018
Head torque on campbell hausfeld 7hp 80 gal serial #110899861?
I'd Google the number on the pump or call Campbell directly and ask them. You could also start with a low torque setting any slowly increase the setting as you tightened the bolts in sequence over and over until you feel like you've got them fairly tight. Run it for about ten minutes, allow it to heat up & torque the bolts again.
12/19/2017 5:09:02 PM •
Campbell...
•
Answered
on Dec 19, 2017
Looking for Gauge #GA015800AV
I usually just find a work-around when it comes to obsolete gauges. Just leave that gauge there or plug the hole. To gauge tank pressure just remove the safety valve and install a tee fitting, reinstall the safety on one side and thread a gauge on the other fitting. For adjusted pressure gauge, just remove a quick connect and install tee fitting there. Not pretty but works great. Good luck
11/7/2017 3:18:23 PM •
Campbell...
•
Answered
on Nov 07, 2017
Need to see a diagram of a campbell hausfeld clean power 37 unloader valve
Most all of the manuals for campbell hausfeld tools are found at www.chpower.com , just look for your model number. Also , campbell hausfeld does not make all their pressure washer pumps. Yours may be another brand. To find who makes yours look on ebay. Make search for {pressure washer pump only} and look for one that matches yours. Then look for that breakdown. Good lu ck.
11/7/2017 3:07:06 PM •
Campbell...
•
Answered
on Nov 07, 2017
Not finding what you are looking for?