20 Most Recent
Black & Decker RD1440K 85th Anniversary 14.4V Cordless Drill/Driver Kit - Page 11 Questions & Answers
Regestering my new cordless CDC1800 dril
if this is a Black and Decker, go to their website at the name and then .com and in the header area you will find a link on the right side that will allow you to register the tool.
Need a charger for 24 volt B&D fire storm--
the charger you need is PS1MVC and you can buy it online from Blackanddecker.com if not look in you local phone book for tools and you might be able to get it from a big box store like Home Depot. Let me know if you need any more help
Replacing the chuck on black & decker drill
remove the chuck retaining screw LH thread, and then find a bent handle allen wrench about the chuck capacity and insert the shorter piece in the jaws and tighten, Shift the tool to the low position (if it has one) and the selector to drill only (if it has one) position the chuck on a block of wood at about a 30 degree angle so you can strike it counter clockwise and hit it with a hammer, it might take a couple times but it will come off. Reinstall in reverse order,
Firestorm Cordless Screwdriver. 10mm 14.4v
go to Dewaltservicenet.com and in the middle of the page towards the bottom type in your model number and it will direct you to another page where you should be able to find a manual. If you want to give me the exact model number I will find one but this is where I would go.
NEED REPLACEMENT 7.2 VOLT BATTERY PACK FOR B&D
I have tried 2 different sites for this model with no luck, I would suggest going to Dewaltservicenet.com and under service center locator or service locator typing in your information to locate one close to you so you can talk direct with them Sorry I don't have better information for you.
The motor fell apart and need to put it back
Get a large plastic bag and put all the pieces in to it. Shake bag for 10 minutes. Look into bag, has drill reassembled? If not, shake again for 20 minutes. If this fail to reassemble drill, throw bag into land fill, and buy a new drill. Thank you for your support of BD.
Is Hammer adjust collar attached to chuck?
I looked at a old schematic for the 5078 and it appears that it might come off after chuck removed. The chuck is threaded and if you have the 2 speed model, shift it to low and put a bent handle allen wrench into the jaws and chuck on workbench or block of wood with long portion at approx 30 degree angle and strike the handle, you will be hitting it counter clockwise to remove.
I have a B & D Professional 1965 and need to
u probuly got sumthin jammed in side it such as a piece of wood to metel sheres (that could be a real pain in the ***) u sho really assemble it and take it out then if dat never did it talk to the manufacter.
REGISTRATION OF DRILL
FixYa is not the one registering the tools, but you can go to BlackandDecker.com and in the header area on the right hand side there is a link to register your tools. I have had good luck with this
Chuck removal
There is a screw in the bottom of the chuck. It has a standard thread. Clamp the chuck in a vise, find a screw driver that fits as snug as possible, to prevent stripping the screw, remove the screw and pry off the chuck. An impact driver will simplify the removal, if one is available.
Cant find registration site
The header says you have BlackandDecker.com and if so go to the site I just listed and in the header on the right hand side you will find an area for the registration. If I have helped you would you please rate my information accordingly and Thank you
Not finding what you are looking for?