20 Most Recent
Black & Decker RD1440K 85th Anniversary 14.4V Cordless Drill/Driver Kit - Page 10 Questions & Answers
Need battery charger for black&decker 4.8v
The replacement part is :
Part Number: 90500901
Description: CHARGER
Status: Active
List Price: $6.69
from http://www.dewaltservicenet.com/Products/PartDetails.aspx?partid=277868
Won't take a charge. batteries are good
why?
The charger is designed to charge all the batteries at once. The only suggestion is that you measure the voltage of each battery to see if it has charged.
It one or more are dead, this why the charger cannot charge them.
My client has a drill press BDDP100 Type 1 - broken chuck
McMaster- Carr ships every where. www.mcmaster.com
There is probably a Grainger location in south Florida, they would ship any where you want. www.grainger.com
There are a few different tapers used on drill chucks but they are pretty standardized: you don't need the black and decker part, you just need a standard chuck of the correct taper. try to get a basic Jacobs chuck they will last much longer than the one it came with.
How do i change the drill bit
Put the key in and turn counter clockwise. If the drill got wet some rust may have formed. Sometimes those chucks get real tight. A small tube (cheater) that is longer than the key will give more torque
to loosen the chuck. Slide the tube over one of the key shafts. You can spray a bit of penetrating oil around the chuck gears.
Trying to mount blinds in kitchen, walls plaster
Is there a space between the back of the drywall and the stone? Or is the drywall tight to the stone? Either way, you need a masonry bit, I hope you have one, a hammer drill would be real nice, but you can muscle through it without one. You can try a smaller bit as your first cut , then go to the next size. Makes it a lot easier to drill. If there was a space behind the drywall, they make all kinds of fasteners for drywall only, they will hold quite a bit, but might not be enough for blinds that are going to be yanked on.
Black and Decker corded drill won't tighten around a bit.
the chuck sounds like it is bad or maybe stuck from rust, what you can try and do is spray some WD-40 on the jaws and then try and holding the collar with a glove and run the drill SLOWLY in forward/reverse and see if it loosens up if not you will need a new one.
I cannot get to registering my new cordless drill,
I finaly found a way to register the drill on the internet, I kind of blundered into it, so I got it registered. I don't think I could tell you how I did it. So I got it set up, I couldn't get ahold of any one on the phone either.
What is the output of the charger for the B&D
The output power will be higher the the battery itself, a 14.4V will be up around 16-18 Vdc. an 18 V will be 20-21 Vdc. Now this is if your testing it with a multi meter and it is not under a load.
Need new brushes for 1983 black and decker hammer
I'd suggest calling the Customer Service line who can put you in touch with your local Service Centre or authorised repair agent. These items are classified as spare parts and generally need to be ordered in, dependent on availability - 1800 444 224
Interchageble cordless batteries
not likely most batteries may look similar, but will not fit in the wrong device. Also if it did fit it would burn up your motor quickly. is there a problem with the 18v set-up?
Not finding what you are looking for?