20 Most Recent
Sony FD Trinitron WEGA KV-32FS100 32" TV - Page 7 Questions & Answers
Tv doesn't turn on.
Does this have a replacable lamp? If so it will do exactly this. If it does it's probably fried.
3/27/2009 9:31:01 PM •
Sony FD...
•
Answered
on Mar 27, 2009
Sony tv timer light flashes wont turn on
Same exact thing happened to my 27" Trinitron purchased in 1998. I tried all the rudamentary stuff that Sony had on their esupport page, but nothing worked. In our case, it went out while my daughter was watching it. I think the time has come to scrap it, and consider a different television, and I don't think I'll go with Sony this time. I hope the rest of you have better luck.
3/26/2009 1:44:00 AM •
Sony FD...
•
Answered
on Mar 26, 2009
TV not responding to remotes
I ASSUME IT'S JUST THE REMOTE YOU'RE SPEAKING OF- FIRST, IF YOU HAVE A DIGITAL CAMERA, OR CAMERA PHONE, AIM IT AT THE INFRA-RED LED'S ON THE FRONT OF THE REMOTE, AND PRESS BUTTONS [LIKE POWER OR CHANNEL] - THE CCD'S USED IN DIGITAL CAMERAS ARE VERY SENSITIVE TO IR, AND YOU SHOULD SEE A WHITE LIGHT [IMAGE] OF THE LED'S, EITHER STEADY, MOMENTARALLY, OR PULSING. IF THE REMOTE HAS BEEN DROPPED, THERE IS A CCHANCE THE CRYSTAL CONTROLLING THE FREQUENCY HAS BEEN DAMAGED. TRY A UNIVERSAL REMOTE, ALTHOUGH OFTEN YOU MAY LOOSE SOME FUNCTIONS, OR THE BUTTONS REACT DIFFERENTLY THAN LABELED. SELDOMLY, BUT IT DOES HAPPEN, THE IR RECEIVER SECTION OF THE SET ITSELF CAN FAIL. THE IR RECEIVER [LOOKS LIKE A DARK LED] CAN FAIL, AND THEY'RE COMMERCIALLY AVAILABLE AT RADIO SHACK
3/17/2009 4:14:56 PM •
Sony FD...
•
Answered
on Mar 17, 2009
No pictoure or sound.
check your pwd supply's Transistor or Mosfet
or Check your Horizonetal Transistor or Mosfet may be it is damaged
If it is damaged replace it
3/15/2009 10:00:11 AM •
Sony FD...
•
Answered
on Mar 15, 2009
"No Signal"
Might need a tuner, I suspect if you arent seeing any snow/static you probably need to press the tv/video button untill you get the ANT input.
3/1/2009 1:40:12 AM •
Sony FD...
•
Answered
on Mar 01, 2009
5 blink standby light
Found it. I'll look up the details tonite and post them in the original question.
Dan
2/25/2009 1:30:03 AM •
Sony FD...
•
Answered
on Feb 25, 2009
I have a KV27FS210 sony wega trinitron tv. It
The single horizontal line is a problem with the vertical circuit. Look for a small flat id attached to a heatsink that should be marked LA7837 or something similar. Try resoldering the pins of this IC first. If that does not resolve it, replace the IC.
Keep us posted.
Dan
2/20/2009 1:00:21 AM •
Sony FD...
•
Answered
on Feb 20, 2009
DVD works, but no cable
YOU CAN EITHER SWITCH YOUR CABLES ARE CALL UR CABLE PROVIDER AND IF U HAVE SATTELITE THAN IT COULD MOST LIKELY BE UR CABLE ON THE REAR OF UR HOUSE WHERE UR BOX IS ARE THE CABLE IN SIDE THE DISH. MAYBE EVEN U DIDNT SWITCH THE LINE BACK TO CABLE TRY SOME OF THESE THINGS THEN U CAN SEND ANOTHER MESSAGE IF IT WORKS ARE NOT LETTING US KNOW WAT HAPPENED THANK U
2/6/2009 7:51:08 PM •
Sony FD...
•
Answered
on Feb 06, 2009
Best setup for Xbox 360 for Sony 32" Tube WEGA tv
Hi, Not sure whether you are kidding or not. You don't mention the tv model so I will try to help using a KV-32FS100 as an example. You really only have 2 choices assuming you have a current model xbox 360. The component cable that comes with the xbox has 6 connectors, a green, blue, red, yellow on one part and a white and red on the other part. On the back of the tv below and to the right of the s video connector are inputs labeled Y, Pb and Pr and are colored Y is green Pb is Blue and Pr is red if they aren't colored that is the correct order. Don't connect the yellow to anything. The red and white on the other part of the cable go directly to the right of these connections. It will say audio and L and R they should also be colored but if not white is L and red is R. There is also a small switch at the xbox end of the cablewhich you need to slide to HDTV. Once you are powered up don't forget to enter the setup menu on the xbox and select the settings for your tv. Again without knowing the model most wega tvs limit the component input to 480p which was the limit of a dvd. I hope this is helps.
2/4/2009 2:34:15 PM •
Sony FD...
•
Answered
on Feb 04, 2009
Sony tv went off
Three blinks - B+ over voltage protection (OVP), unit goes to the standby mode then displays the 3 blink fault. This is also a problem in the power supply circuit, check T603 and R672.
1/31/2009 12:14:32 AM •
Sony FD...
•
Answered
on Jan 31, 2009
Sony trinitron 32
Hi, tubes getting tired, band-aid fix you can do is remove back of set and turn up(clockwise) the screen control( small black plastic control mounted on side of flyback transformer, do not turn the knob marked focus) until you see a whole bunch of white lines across the screen, then turn same control counter-clockwise until all the lines go away, try several different channels to be sure all the retrace lines are gone, you`ll get up to 1 year more use out of it, than she`s done, good luck, BMW Rider
1/28/2009 8:33:04 AM •
Sony FD...
•
Answered
on Jan 28, 2009
Sony kv-32LS60U
LINE DRIVE FAULT, YOU NEED A TV TECH TO LOOK AT IT. LIGHTS ON THE FRONT FLASHING IS A BREAK DOWN CODE. UNIT HAS GONE INTO FAULT PROTECT MODE.
1/17/2009 5:45:20 PM •
Sony FD...
•
Answered
on Jan 17, 2009
Green screen on monitor
Sony carry spares for 15 years. The question is, do you want to keep it, or buy a nice new LCD widescreen one .
1/14/2009 4:33:19 PM •
Sony FD...
•
Answered
on Jan 14, 2009
Screen went black and never ressurected
It is repairable.Open the TV and check the fuse and then the flyback transformer for any loose soldering. check for obvious burnt transisters, resistors, capacitors etc. the flyback is the component that has a wire to the picture screen on the inside of the TV. Be careful. Capacitors and picture tubes retain high current. If you don't know what your doing take it for repair.
12/29/2008 6:19:35 AM •
Sony FD...
•
Answered
on Dec 29, 2008
Not finding what you are looking for?