20 Most Recent Philips 60PP9202 60" Rear Projection HDTV-Ready Television Questions & Answers


After the IC replacement, convergence adjustments should be done. If you wish to get some details; visit the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/ Details of this adjustments are given.

Philips 60PP9202... | Answered on May 02, 2017


Hi,
I would highly recommend you to go for selling it because as your not interested to use it as the primary TV..The replacement may or may not cost you higher than 150$ which can be decided based only on seeing the TV..But if you wish not to sell this for such a low price you can always go for replacement of screen my friend!..which can be found from http://www.olx.com/q/screen/c-366/p-4
Please post for how things turned or for further assistance too.

Hope this may help;

Regards,
VOTIT

DON'T FORGET TO RATE

Philips 60PP9202... | Answered on Dec 13, 2016


see attached photo, it is a convergence problem.

If you have similar problem in customer menu is a way with the remote to adjust.

If it will not adjust there then the convergence chips are bad.

SD TECH

Philips 60PP9202... | Answered on Jun 23, 2015


TV powers on, then cuts off by itself.  I have no picture, and will not let me control the tv. with remote, or manual. 

Philips 60PP9202... | Answered on Apr 20, 2015


Through the front of the TV. Remove the speaker grille (IT SNAPS OFF & ON) & there is a lamp cover with 3 screws holding it in place, near the left speaker.
That lamp part#: 915P020010 $49.00 TO $100.00
http://www.shopjimmy.com/dlplamps?tv_brands_select=Mitsubishi&tv_models=Mitsubishi+WD-62525

Philips 60PP9202... | Answered on Jun 05, 2014


Some projection TVs have speaker grilles that snap off for cleaning.

Philips 60PP9202... | Answered on May 22, 2014


John,
You wrote that the power light is on. Is it blinking? A blinking light can be a service code that can be researched online and narrow down the issues.

Philips 60PP9202... | Answered on Apr 24, 2014


Have you looked at the Green Picture tube to see if there is a convergence magnet that may have come off? Not sure if this model had them but it's worth looking into.

Philips 60PP9202... | Answered on Mar 26, 2014


Its a convergence problem. The three color guns have drifted and it shows on the edges. Typical of an old projector tv
These will help
www.youtube.com/watch?v=esk4nYZKFcg how-to instructions: www.ehow.com/how_2034880_perform-convergence--tv.html

Philips 60PP9202... | Answered on Mar 08, 2014


All you need is a free HDMI port. The Chromecast comes with a USB power adapter to plug into the wall, or if you have a free USB port on your TV you can use it. It works great, but there is a bit of a learning curve to understand how to connect it. I use my Windows 8.1 tablet and my Windows 7 notebook.

Philips 60PP9202... | Answered on Jan 12, 2014


The crt fluid needs to be repalced carefully and correctly...This is why we created step byt step instructions for our kits on our website www.TvRepairKits.com . In msot cases if you cleaned up the spill before powering up the tv would be fine....but its not always easy to get all the spill off the board.....look around and see if you find any burnt parts....if so post a photo here....

Philips 60PP9202... | Answered on Apr 24, 2013


I suspect you are asking about the convergence or brightness. See below for both common problems and fixes

Below are two of the most common problems encountered with projection TV sets.

Problem #1 - CONVERGENCE PROBLEM

Projection TV sets need to have all three colors - RED - BLUE - GREEN - lined up correctly on the screen in order for the video to look normal. When its out of alignment the video will look 3D, wavy, distorted, etc. Most of the time you just need to adjust your convergence in the TV menu. If you cannot adjust it in the menu - then your convergence is broken and needs to be repaired.

This is a very common failure on Projection TV sets and a fairly simple DIY fix.

Common Symptoms include....
  • Screen looks 3D
  • Colors don't line up
  • One or more colors can't be adjusted when using the convergence menu.
  • Screen is bowed or warped.
  • TV shuts off after powering on - TV may also make a chirping noise.
Here are some photos of convergence problems.


1d5e2cf.jpg


ff5b9f6.jpg
7deade1.jpg

Here is a quick test....

Using your original remote go-to the settings menu then goto the convergence section.

Try to adjust the red and then the blue convergence.

You should be able to move RED and BLUE in all directions - up, down, left, and right.

If you can't move them in all directions or cant move them far enough your convergence chips are bad and should be replaced. This is a common problem.

Note: If you TV has as flash focus or magic focus button only try pressing the button. If it fails to fix the convergence your need to fix it. See below for a solution

47a7bc4.pngCONVERGENCE SOLUTION

You will need to replace the convergence chips and possibly some convergence resistors and pico fuses.

This is a a fairly easy DIY job if you know what you are doing. If you have never done this before we would advise calling a shop or if you want to do it yourself get a complete kit with instructions and support from TvRepairKits.com

Their kits include a step by step instruction guide, original OEM Sanyo STK chips, convergence resistors, pico fuses, thermal paste, email/phone support, etc.

Problem #2 CRT Fluid is Cloudy

Projection tubes have a liquid coolant that is used to keep them from overheating. After many years the coolant in the blue and green tubes will become cloudy and cause the screen to look dull, red/orange, etc. You may even see halos around video.

Pic of a set that needs the fluid changed. Notice how dull the colors are and how white the screen looks. The screen may also look red, orange, dull, etc.

BEFORE

7c190d8.jpg

Set after fluid change. Notice how bright the colors are now. Everthing looks crisp and sharp again.

AFTER

a798d23.jpg



724bcba.pngSolution #2 - CRT FLUID FIX


What you will need to do is replace the coolant and clean the crt. You can get a repair kit from TvRepairKits.com . It includes replacement coolant,step by step instructions, support, etc.

Philips 60PP9202... | Answered on Apr 19, 2013

Not finding what you are looking for?
Philips 60PP9202 60" Rear Projection HDTV-Ready Television Logo

723 questions posted

Ask a Question

Usually answered in minutes!

Top Philips Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76177 Answers

matt martin
matt martin

Level 3 Expert

1257 Answers

Cindy Wells

Level 3 Expert

6048 Answers

Are you a Philips Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Philips Televison & Video

  • Philips Televison & Video

Most Popular Question

remove speaker covers clean

  • Televison & Video
Loading...