Top 20
RCA P52960 52" Rear Projection Television Questions & Answers
My rca d52w26 convergence is gone.
Look in the on screen menu for convergence and if it is not there you have a open ( bad ) protection part on the main board, a kit exists for most of these sets for this===buttons alone will not likely help here.the convergence menu missing is a result of this and the part in question is often bad because of bad solder connections.If you need more info let me know.
How do i get the pip, Picture in picture to work ??
If it has the feature buttons on the remote for it, swap, position etc.Some older sets have to have signal routed to one of the rear video inputs for a source for the PIP. Newer sets have two tuners--one for main and one for PIP---if pulled up the swap will switch one picture for the other--some allow both on the screen at same time side by side.Read the owner manual to see if the set has PIP.
Where are the convergence chips
Your model has one IC which powers the convergence circuits. Its on the small Convergence power board attached to the heat sink STK730-130 I am attaching a pic of that board for you
My RCA P52960 52in. rear
We calling convergence problem.
Re solder fly back terminal ( transformer)
Replace pico fuse 400mA(little red box fuse) beside fly back.
Go to set up, convergence, select auto convergence and your TV will work perfect.
I will be here for any future question.
Thank you for visit fix ya.
RCA P52960 52" Projection TV. When the 5A 125V
It is an indication of shorted parts on the power supply.
Replacing the fuse alone can't solve the problem.
I've suspected that you have a short on the following parts (rectifier diode, regulator I.C.) on the power supply section but needs to check by a qualified technician to isolate the problem. It is quite technical and not diy.
If you unit is under warranty then send it to the nearest service center of your manufacturer then avail the warranty.They will fix it for you for free and/or a little charged only.
pls rate my help.
Thanks for using fixya.
I have model RCS P52731wk.
THERE IS A FUSE, it is located inside where the power cord connects.
Let me ask does power light come on for just a moment at all?
SD TECH
My picture is hourglass shaped
sounds like a keyway setting issue i dunno if your tv has has a setting to adjust this so you might need shop call to adjust this
Chirping sound and will not
chirping sounds generally but not always indicate a faulty flyback transformer and a shorted horizontal output transistor. but it always first place I look to as a tech when it chirps
Not finding what you are looking for?