Panasonic Panafax UF-585 Plain Paper Laser Fax - Answered Questions & Fixed issues

Press Function 7 monitor slowly 4 times * 6 scroll down to SHIPMENT SET set 2 wait for the fax to initialize and come back to READY

Hello I have a panasonic kx-FT983CX, it can't copy but when copied is not clear.... Please tell me.Thank you very much!

Hello,
It sounds like the fuser unit is on its way out. The cost to fix may out way the price of a new one. You should bring it in to a certified Panasonic repair centre to get a quote though. Fuser units are worth about $300. It could also be a failed toner. Try taking the toner cartridge out and gently nock it back and forth to free any stuck toner.
Chris

They are nice machines, pretty bulletproof. Repair of this machine is worth it. Panafax tech for 15 years

hi hahudson,

I think you need a physical service of that fax machine.


mastergani

To set Outgoing Fax Number/ ID follow the follwing steps: -
- Press FUNCTION, Press 7 (Set mode will appear on display)
- Press 1 (User Parameters Settings)
- Press Set repeatedly until display shows ID
- Enter your Number/ ID (max. 20 digits) by using the key pad

For further information you may refer to User Manual for Panasonic Panafax UF-585 Page 29

Hope it helps! Good Luck!
CreativeTECH

Check the following information....

http://www.fixya.com/support/t144397-printer_error_info_code_021

press

function
7
monitor key slowly 4 times
* asterisk
6
scroll down to SHIPMENT SET
set
2

wait for reboot

enter the first number
press set
enter second number
press set
enter third number
press set
continue or press START to send.

Unplug the power cord for 30 seconds.

On top of the operation panel by the blue slider knob

press

function
61
set
print

you can only see the last 50 transactions

The battery is above the display, next to a sliding blue lever.

Open the toner door, pull up the panel about 1 inch. Pull out the holder.

When you removed paper from the machine, did it rip at all? If it did, a small scrap could have been left behind, causing the jam code. Depending on where the machine is located and who uses it, there might also be a foreign object lodged in it (like a staple or paper clip). If you think there is nothing in there causing the jam, try turning the machine off and turning it back on, and see if it still shows the jam.

press

function
7
monitor key slowly 4 times
*
6
scroll down to SHIPMENT SET
set
2

wait for the reboot

The toner cartridge is the only possible failure. Try another one

Push the cartridge forward.

If it is still stuck, remove the sliding drum cover.

remove the toner cart, cassette and rear tray and unplug the machine
set the machine on its back.

wad up a small piece of electrical tape and stick it into the black U shaped sensor on the left side.

the small tab on the end of the paper cassette is broken off, but you don't need it....just apply my fix.

Sometimes you can go to "print reports" then activity report and print your send report

Try another one, the toner cart IS the problem.