Question edited for clarity.
Question moved from Cars and Trucks category.
Look at the corners of the doors that hold the aluminium frame together and if it is a modular door, tighten them up. If it is a solid door, adjustment can be made by shimming behind the bottom hinge with a piece of cardboard. This will move the bottom out and up.
..
Check the opening limit dial on the garage door opener unit. You can locate the dial that controls the opening limit on the opener unit and use a flat head screwdriver to turn the dial counter clockwise until the door stops about an inch and a half away from the stop bolt. Then, test the door and make sure it does not slam into the bolt. A video tutorial on how to adjust the opening limit of a Craftsman garage door opener is available on YouTube.
If the above step does not work, check the limit switches on the garage door opener. Most garage door openers have limit switches that control how far the door opens and closes. Improperly adjusting these switches can cause the door to stop halfway. Consult your garage door opener's manual to learn how to adjust the limit switches. Make small adjustments until the door closes fully. Craftsman garage door opening too far and hitting stop bolt easy adjustment (youtube.com)
earth-friendly products is good for us this means it's products that was made from things that could be reuse and made better for our health and environment will be better
Question moved from Cars and Trucks
Are they vertical lifting sash windows? They have hidden counter-weights in the frame. Very often the string will break so you are lifting the full weight of the frame and the glass.
..
Exterior rendering is the process of applying an external wall covering to the exterior of a house in order to provide added protection to the bricks it's built from.
The external wall covering protects bricks from the effects of weathering and erosion which can, over time, cause both cosmetic and structural damage.
However, the covering alone is not sufficient as this too is susceptible to damage over time from weather and other environmental factors. Therefore, once the wall covering has been applied, it's usually then painted or a wall coating in order to stop it from cracking and prevent damp from seeping through it and into the home. It also requires regular maintenance and re-painting in order to repair any damage that may occur to the paint or wall coatings.
The whole process of exterior rendering is usually carried out by coating specialists like Apex Coating Services.
Make sure the sensors are correctly positioned, free of dirt and obstructions, and that the sensor wires are undamaged. Additionally, consider changing the batteries in the clicker.
you did not provide info on the type of the paint and what surface it will be used on - there is difference between the floor, desk, wall and car body... all are flat surface but adhesion and work of the paint differs.
depending on the pre-existing paint, but you need always to "key-in" using 120 grit paper or 150 grit screen.
if paints are of same type, then paint in - if these are two different paints, you need to strip or isolate old paint, and then use new paint.