Top 20 Sharp AR-M205 Copier Questions & Answers

You polygon motor has failed. It is a pain to replace and kinda pricey, you will want to call a service tech to change it out. I’m happy to help further over the phone at https://www.6ya.com/expert/ethan_e84416e0b13809d2

the tone is it for the machine because the machine is showing that the developer needs to be replaced

Decrease the density Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

decease the density or check the fuser unit (hot part) may ahve previous print burned on its rolllers Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

L6 is a motor lock code relating to a paper cassette. There should be a 2 digit code after the L6. Please tell me the model sharp and the 2 digit code and I can help more.

See previous answers on this website: http://www.fixya.com/support/t5481107-sharp_ar_5516_printers_error_h5_h4

You could try a Sharp AR-M207 driver you can get those from here. http://www.sharpusa.com/CustomerSupport/SharpCareCenter/downloadfiles.aspx?modelid={B5785384-76A0-4751-82AC-FB56BB792A87} I’m happy to help further over the phone at https://www.6ya.com/expert/ethan_e84416e0b13809d2

A little more of a description of your problem would be helpful.... Copier Collin Houston TX Copier and Imaging Expert

how to slave error H4

From control pannel of your pc ,go to the scanners and camera and see your AR_M205.then dubleclick on it.ok?

check the main motor belts and gears. hope this helps

f2 codes are fuser

5 02 Copy lamp lighting abnormalityH2 00 Thermistor open H3 00 Heat roller high temperature detection H4 00 Heat roller low temperature detection L1 00 Scanner feed trouble L3 00 Scanner return trouble L4 01 Main motor lock detection 11 Shifter motor trouble L6 10 Polygon motor lock detection L8 01 No full wave signal U2 04 EEPROM read/write error (serial communication error) 11 Counter check sum error (EEPROM) 12 Adjustment value check sum error (EEPROM) 40 CRUM chip communication

H2 Trouble code is a problem with one of your thermistor. I would start by removing the fuser and then check if your thermistors are damaged or need to be cleaned. After you clean or replace use Simulation 14 to cancel the error. Perform the following procedure to enter the simulation mode. "#" key Interrupt key "C" key Interrupt key "14" Main code Start key I’m happy to help further over the phone at https://www.6ya.com/expert/ethan_e84416e0b13809d2

Follow the instructions some jams are very hard to see.

The error sshould be a 4 digit code like e1-00 or e1-82 Each of these codes differ greatly. so to answer your question I would need more info. I’m happy to help further over the phone at https://www.6ya.com/expert/ethan_e84416e0b13809d2

there is some thing wrong my dear you made a mistake there is code paper L6 not a 6L, if that is L6 you have problem with polygon motor polygon motor is locked may be jammed or power issu

I use it for CHANNEL abbreviation. googling it gets a lot of other answers. Then it depends on context.

enter # interrupt c # .when display shoes nothing enter 14 and copy .

olsonbros.com/sharp/support/.../trbl-mx2300g_2300n_2700g_2700n.pd...