20 Most Recent
Sharp AR-M205 Copier - Page 3 Questions & Answers
MON PHOTOCOPIEUR AFFICHE LE CODE
L6 = Polygon Motor Lock Detection
Polygon motors are not serviceable items.
Try switching the machine off/on. If the code doesn't clear then you will need to get the motor replaced. Quite often the motor will have made a screeching or rattling noise before it fails.
Hope this helps
How can I fix the H2 error
The error code should be in the format H2-00. In this case you are having issues with the temperature of your fuser. This is the unit on the right upper side of your machines that gets very hot once the copier is warmed up. Most commonly that units is replaced or rebuilt depending on how dirty it is, also it is very possible that you can just clean the thermistors inside of it. You can pull your fuser out by removing the two or four screws that hold it in and disconecting the two or three wires that are behind the back cover. I’m happy to help further over the phone at
https://www.6ya.com/expert/ethan_e84416e0b13809d2
Sharp AR M205 service mode
the code to enter the sim mode is #, interrupt ,"C",interrupt. it is time sensitive so you have to be quick entering it
Ar5516 developer spilling out
hi 1 might be developer is very poor quality (generic) 2 check biasing in sharp normally it,s developer issuer and also in this model if u turn mag roller while replacing or just turn and re install in your machine will spill developer
Error code E7
It would be helpful to know the error sub code. With the error showing press and hold your start/copy key, this will provide the sub code.
Thanks
Follow me on Twitter @CDOS_Service
Best way to fix a Sharp machine
best way of fixing a sharp machine no matter how small the problem because its sometimes only a symptom than a causeis contact a technician, because the longer you take the more damage you cause, the more expensive the repairs, and a good chance you don`t end up with an expensive paper weight
Not finding what you are looking for?