20 Most Recent
Sharp UX B700 Plain Paper Inkjet Fax - Page 8 Questions & Answers
Sharp fax manual
Ugh! It accidentally went out with this week's recyclables literallly within an hour of this post. I'm trying to contact the gal who got my fax machine as she said she was able to get one off of the 'net. I'll share that if she does.
So sorry to get your hopes up. I had it in my hands just a few hours ago. :(
Sharp ux-b700
do you hear the tires trying to pull the paper? if yes clean with alcohol ( may be slipping)
Receiving fax
your fax machine set to auto mode with the help of receive mode button of machine, this setting will give you automatic faxes.
UX-B700 fax/printer
Sounds like you may need to clean the optics. Open up the area where you insert the original to copy, there you will find a small long glass that needs to be cleaned, I would suspect there is white out on this causing you lines or it may just be dirty.
Hope this helps...
Lbcoaster
Receive faxes but can't send
Instead of trying to send a fax try to call the number from a different phone. To see if the receiver is busy all the time..
Need help
I am noting receiving my faxes I get a no service message
is does ring but won't answer help
Can't copy
paper might be stuc in the machine at the roll.
Open remove piece of paper. Unplug maciine and try again
Sharp UX105
I just have one thought. You may have accidentaly turned off the auto recieve function. This is normally a program function on the display panel. Make sure it is set for auto recieve. Thats all I can think of.
Fax won't print
check with original cartridges or its carriage cable may be suspected, check with the expert technician.
Sharp fax ux b700
you have to select Auto mode of reception for fax machine with the help of receive mode button of fax machine. this setting will set machine for automatic fax reception and you get fax within 2 or 3 rings as set to your machine.
Can not fax any document
when machine clear this problem may be solved, First you make setting as i said to machine. Press buttons respectively as i written function 9 * 8 # 7 then start button , it gives DIAG MODE then press satrt, With the help of star button go to memory clear and press start key. machine cleared memory, gives printing of MEMORY CLEARED. this setting will solved your problem.
Not finding what you are looking for?