Top 20 Peavey PR15 400w PA Speakers - Page 8 Questions & Answers

You should be able to connect the XLR l&r outputs to the amp or the 1/4" l&r outs to the amp. Check out the manual here. http://assets.peavey.com/literature/manuals/FX_Mixers.pdf http://assets.peavey.com/literature/manuals/FX_Mixers.pdf

Depends on the end result you want. If you're using a high impedence mic or a low with a transformer,jst plug it into the input jack, drop the gain down and contriol your violume with the master. A better way would be to plug a small mixer into the effects loop/line in jack.

It should be a 5 amp fuse, and usually states that around the fuse holder on the rear.

Contact Peavey customer service at this link- Peavey com

Peavey com contact peavey directly and they'll send it to you.

yours is 1989 to 1991,sn 03557665 is 1988 sn 0368333 is 1990 Peavey Falcon User Manual Page 4 Peavey Falcon Made In Usa With Ohsc Peavey Guitar

This is not user servicable. Here is a link to the service locator for peavey- Peavey com

RFeplace the fuse, then call Peavey Ciustomer Service.

look here, http://www.ko4bb.com/manuals/index.php?dir=06_Misc_Test_Equipment

Unfortunatly this could be any of a number of problems. i suggest taking it to the repair shop.

There is an external speaker jack on the back. Plug in a cab of your choice down to 2 ohm load. enjoy.

To get a replacement, Call Peavey and ask for the parts department. They normally sell things cheaper than you'd expect, and it will be the correct part.

There are a lot of possible problem areas it could be. I would first check that the speaker is working correctly. If so, I'd clean all jacks and pots. If that doesn't do it, it'll be time to take it to the shop.

You might try checking the capacitors and inductors wired inside. A blown cap is usually obvious, the inductor might be less so. But it shouldn't be too hard or costly to replace either. I don't have experience with this brand of speakers (or large high end speakers in general) but unless there is mechanical damage to some speaker component like the coil or cone, the electronics might be the next thing to check.

The best bet is to call Peavey directly. Here's their contact page Peavey com

Most of the time amplifier hum is caused by the outlet that it's plugged into, maybe no ground or there's other appliances on the same circuit causing interference? And sometimes it's as simple as a little internal feedback, certain C notes on the Guitar cause distortion with tube amps, the best fix is a $100 power conditioner like made by Monster cables or others.... hope this helps?

YOur bet solution is to contact Peavey Customer Service. Here is their link- Peavey com

Contact Peavey directly for the correct info.

Contact Peavey Customer Service. They can email you the schematic, and you can get the part directly from them.

To adjust the intonation on a guitar you need the following. .. a electronic tuner and a small philip screwdriver when you tune a string say low E you play the note open and adjust tell it's in tune then to intonate play the low E at the 12th fret producing a Harmonic, view the tuner it will be sharp or flat, turn the small philip screw on the bridge adjustment it only takes a small turn one way or the other so go slow once the string is tuned at the harmonic note check to see if it's in tune played open, keep tuning and adjusting tell the strings are in tune open and at the 12th fret on all six strings once intonation is set properly the guitar will sound better really hope that helps?