20 Most Recent Canon FAXPHONE L170 Plain Paper Laser - Page 3 Questions & Answers

You can send a fax to up to 142 fax numbers, using any combination of dialing methods:
- One-touch Speed Dialing (up to 32 destinations)
Press the desired One-Touch Speed dial button(s)
- Coded Speed Dialing (up to 100 destinations)
Press [Coded Dial] > enter the 2 digit code (00-99) using the numeric buttons and be sure to press [Coded Dial] before each code
- Regular dialing and redialing (10 destinations)
Enter the number using the numeric buttons or [Redial/Pause] and be sure to press [Set] after each entry with the numeric keys

After all the numbers are listed, press [Start]. The machine will scan in the document (memory) and then begin sending it to the destinations in numerical order, starting with One-Touch, then Coded and finally the numbers dials with the numeric keys.

You can also create a group if you frequently send faxes to the same group of people by first saving them as One-Touch and then adding them to a new group.

YOU NEED TO CLEAN THE LASER UNIT happy faxing omnipresent

You just pull down the front cover that is just below where the copies come out of the machine. You will see the toner cartridge. It has a small "handle" on it. It just pulls out the front of the machine. Then just unpack the new one making sure to remove the seal tape if it is installed on your new toner. Then re-install the new cartridge and close the door. If you have your users manual for the machine, the instructions are in the manual. If you are using a OEM Canon toner cartridge I believe the instructions are included in the box.
Good Luck and Thank You for using Fixya.
WheatlandServices

Try and clean the laser glass. It should be right above where the toner cartrige slides in.

Hello,

There are a few possible reasons that can cause this problem. First, the fuser assembly may be damaged or at the end of its life. The solution is to replace the fuser assembly. Repairing a fuser assembly is generally not recommended because the fuser is considered a consumable printer part and not worth the time or effort to fix. Second, the toner cartridge may be defective and letting too much toner out at one time, the solution is to replace the toner cartridge.

Take care.

You can do clear all under service mode, but you will loose all data.

MENU and #, clear, ok, all, ok

reenter all your sett. and try to get fax from someone.

In user mode is under RX sett. - recive mode.

Hey!Press menu and the # key,It will say on the display 1 sssw!Use the aroows right and go to report and press set/ok!Use the arrow again to go to system dump and press ok/set again and it will print the report with the totals on!!Good Luck!

For some reason it thinks it is out of paper

AABGT5UYGY?

It might be the fuser film thats busted,i recon the u have changed the cart?Does it make a noise when u print?

U can try by holding down the stop button,unplug the m/c and while still holding stop plug it back in.

Make sure that the page size of the doc is set to A4,What happens when u make a copy?

in service mode menu and # find clear all and set.

if does not help buy another fax- bad PCB

remove the cartridge and see if has some band or some sticker on which should get off (see on the box of the cartridge it must write if something like that should be removed) , or just remove the cartridge and putt it carefully and it might be not set good.
Please rate the post if is it helpful for i to know do i should post some more information

Regards

By pressing the menu button,button is located left of LCD display.Scroll to usersettings.Press ok.Under usersettings you can change the terminal id,volume telline settings,user name and tel.