Top 20 Casio G-Shock GW500A-1V Wrist Watch Questions & Answers

Question moved from Sharp Televisions to Casio Watch. Every 60 seconds or every 60 minutes? Do you see 'PS' for low power, power saving on the screen. How new is the battery? https://www.google.com/search?q=Casio+g-shock%2C+chirping+every+60+seconds ..

Try link below by using the module nbr found on the back cover(4 digit nbr in a frame). Timepieces Watches Manuals CASIO

Try link below by using the module nbr found on the back cover (4 digit nbr in a frame). Timepieces Watches Manuals CASIO

here> http://support.casio.com/en/manual/009/qw2688.pdf is the manual.

casio g-shock ga-100

http://ftp.casio.co.jp/pub/world_manual/wat/en/qw2688.pdf

Click this link to download the manualhttp://world.casio.com/wat/download/en/manual/

go here > http://www.gshock.com/support/

Go to a watch repair shop they'll have lots of watchbands for sale.

Analog time follows digital time.Correctly set your local time and analog time will come up correctly as well.If not, try to run the hands alignment procedure (H-SET) following manual instructions.

Facing direct bright sunlight (not behind a window or on a car dashboard) for several hours.

it goes in a small hole in the back of the movement of the watch and connects to the back plate when replaced to operate the alarm.

you should be able to get one off the link below.http://www.watch-band-center.com/watchstrap-h243-For-CASIO.html

I couldn't find your model on thier web site but this range appears to have solar panels to charge the battery. Place your watch in bright sunlight or under a lamp (not a hot one) to charge the battery.If this fails, consult your nearst dealer.

For G Shock GW500Uthe screws holding the ******** are actually just one pin per strap the screw end is for decoration. To remove just get small headed flat screwdriver and push pin through it is fidely but can be done it took me 10 mins first time. Casio sell straps direct for about 10 pound cheaper than putting into casio dealer .

From the main time display, hold down the adjust button until it beeps and your time zone is flashing on the bottom of the display. Then press the mode button once. [AUTO/ON/OFF] DST will be flashing on the bottom. Use the Time Memo and/or Receive buttons to cycle the mode. When it's what you want, press adjust twice.

From the main time display, hold down the adjust button until it beeps and your time zone is flashing on the bottom of the display. Then press adjust again. 12H or 24H will be flashing at the bottome. Use the receive button to cycle the mode. When it's what you want, press adjust.

You hold down the A button for a few seconds until it beeps. The A button is the one that says 'adjust' on it and is at the top left hand corner of the watch face. After that you adjust your home city time by pressing the bottom right hand button. After you hit adjust again the watch face will rotate to the home city time. You can see your home city change in the bottom right hand lcd display. A description of the home city codes is in the manuals you can download from the site posted above

press and hold the adjust button, then the seconds blinks (blinking digit is changeable) press mode to choose for the minute to be change. when you are done just press the adjust button once. i hope i had been helped you.

Sounds like the auto-light is on.

Hold down the light button (the one on the band with the G on it) until it beeps to toggle the mode.