Top 20
Bertini Chrome Stroller Questions & Answers
Have just bought a toddler
Hi, you have to remove the bumper bar and the hood, then click the toddler seat into the opening that the hood goes into, once in, you can then refit the hood but you are unable to use the bumper bar with the toddler seat in position.
Need repair center for bertini stroller
There is a company called Buggy Pit stop which valets as well as repairs pushchairs. I used them when i gave my old dusty broken pushchair to my sister. I had it repaired and valetted by them. They did a great job and they were not that expensive either.Hope this helps. Their number is 020 8861 0038.
Need new wheel
Hi, you need to call the company and ask them for a replacement part. Some companies keep these for several years for a specific model and then there are models that are trial runs, that they only keep parts for 2-3 years past for repairs.
It sounds like yours was made well to start with, so they may have parts for you. I can't find a specific company that would have those. Hopefully you have the books.
Need parts
Hi Diane
Please make contact direct with Dorel Australia -
Our stroller shakes when pushing
You don't mention what make / model you have. Try turning stroller upside down
( without baby in it *-) ) and spin each wheel to see if it runs freely. Try to rock the wheels from side to side to see if there is any play in the axel. On a flat smooth surface do all wheels touch the ground? If the front wheels swivel do they rotate freely without any side to side play? Some strollers have nuts you can adjust others just have Silver domes. Try tightening nuts till wheels get tight then back off just enough so they spin freely try taping domes on tighter using a large socket from a socket set and a hammer so the pressure is around the edge of the dome and not in the centre where it would dent. Silicon spray is the best lubricant for strollers.
On Saturday afternoon, I strapped
Hi.
The best thing to do is contacting Bertini. A part is probably slightly defective.
Bertini are manufactured in Australia. You need to contact the manufacturer directly, or the seller that originally distributed your pram.
Here the contact.
Bertini AU and NZRegards.
Problem with tires
Pick up a kit for bicycle repair. Take the wheel off, deflate, pull the wheel from the rim and remove the tube. Pump the tube up a little, place under water and look for the bubbles. Once you find the bubbles, patch with the bike tire repair kit, deflate, put the tube back in, reattach tire to rim and inflate.
Tyre not inflating
Any bike store or even walmart will carry the tube you need. I replaced all my tubes with thorn resistant ones and added thorn liners haven't got a flat since. Most bike stores will also change out the tubes for a couple of bucks.
Hiw do I get the back off a pottery barn pocket watch clock that has no screws.?
With tread you see dents round the back cover, where an adjustable tool with three pins that could be adjusted to size fits in. When there is no such sign there must be a small latch where a very thin knife goes under and I wish you best of luck, not to break the knife or hurt your self with it. The back should also suddenly break loose. It is not for every body to try attempt this. Wear glasses and gloves. Look for the very thin rubber seal that makes the watch more or less water resistant. It has to go back in place and keep it on when you can.
1/13/2024 8:56:05 PM •
Baby Gear
•
51 views • 0 helpful votes
Not finding what you are looking for?