Top 20
Bertini M5 - TS City Stroller Questions & Answers
Bertini M5 Shuttle
hi I think I could help I bought a bertini shuttle as well if you stand behind the pram on the right run your hand down the right side of the hood there is a push up lever there mine is grey ok you need to push the grey? lever but also on the left and right there is a black lever you must push up al together hope this helps good luck from debbie
Need parts
Hi Diane
Please make contact direct with Dorel Australia -
Our stroller shakes when pushing
You don't mention what make / model you have. Try turning stroller upside down
( without baby in it *-) ) and spin each wheel to see if it runs freely. Try to rock the wheels from side to side to see if there is any play in the axel. On a flat smooth surface do all wheels touch the ground? If the front wheels swivel do they rotate freely without any side to side play? Some strollers have nuts you can adjust others just have Silver domes. Try tightening nuts till wheels get tight then back off just enough so they spin freely try taping domes on tighter using a large socket from a socket set and a hammer so the pressure is around the edge of the dome and not in the centre where it would dent. Silicon spray is the best lubricant for strollers.
On Saturday afternoon, I strapped
Hi.
The best thing to do is contacting Bertini. A part is probably slightly defective.
Bertini are manufactured in Australia. You need to contact the manufacturer directly, or the seller that originally distributed your pram.
Here the contact.
Bertini AU and NZRegards.
Problem with tires
Pick up a kit for bicycle repair. Take the wheel off, deflate, pull the wheel from the rim and remove the tube. Pump the tube up a little, place under water and look for the bubbles. Once you find the bubbles, patch with the bike tire repair kit, deflate, put the tube back in, reattach tire to rim and inflate.
Tyre not inflating
Any bike store or even walmart will carry the tube you need. I replaced all my tubes with thorn resistant ones and added thorn liners haven't got a flat since. Most bike stores will also change out the tubes for a couple of bucks.
Hiw do I get the back off a pottery barn pocket watch clock that has no screws.?
With tread you see dents round the back cover, where an adjustable tool with three pins that could be adjusted to size fits in. When there is no such sign there must be a small latch where a very thin knife goes under and I wish you best of luck, not to break the knife or hurt your self with it. The back should also suddenly break loose. It is not for every body to try attempt this. Wear glasses and gloves. Look for the very thin rubber seal that makes the watch more or less water resistant. It has to go back in place and keep it on when you can.
1/13/2024 8:56:05 PM •
Baby Gear
•
57 views • 0 helpful votes
Not finding what you are looking for?