20 Most Recent
Monarch 9403 Thermal Label Printer Questions & Answers
How do Iget into the gear area of my Monarch 9400 Printer
The Ink reals and printhead assembly are all mounted on the single
black plastic mold which is held down by three mounting screws.Two
of the mounting screws are up front ; one within a long thin well, the
third is in back. Any long thin Philips Screw Driver will do.
There are two spools for the ribbon and one spool
There is one motor and two belts - one belf for each ribbon spool. It's possible the belts are the problem, but it sounds more like it's the ribbon spindle itself. The spindles contain clutches, and when the clutches bind up the spindles don't want to turn. Sounds like you need a new ribbon spindle.
9403 monarch printer/hooked to lantronix print server
If the printer doesn't react when you send a print job to it (either prints, or displays an error code on the display) and just sits there doing nothing, it generally means the print job didn't get to the printer. Check your communication settings. The printer comm settings must match the settings in your software. The default comm settings on the printer are:
Baud : 9600
word length: 8
stop bits: 1
parity: none
flow control: dtr
Communication status not responding on monarch 9403 printer
Hi,
Please make sure that printer has not over heated. You can check requirements in the first few pages of the manual. You can run a power cycle on the printer and then check for the response again. Otherwise, please see the troubleshooting section for any suggestions from the manufacturer to move forward.
Thank you.
Not finding what you are looking for?