20 Most Recent Peavey Sanpera I Amp Pedal - Page 8 Questions & Answers

We would need to know which Peavey PA you're asking about.

I wouldsuspect the input jack needs cleaning/replacing.

Michael; press the helpful button and check the links below for CS 200 X Amp. Peavey Diagrams Schematics Service Manuals Peavey Schematics Circuit Diagrams http://www.clubdediagramas.com/archivo/audio-equipos-de-musica-amplificadores-reproductores-etc-a7/peavey-m168

You can find it here- http://peavey.com/support/searchmanuals

If it has a effects loop output and input on the p.a. head and a in and out on the reverb effects processor, then yes you can, just run the effects loop output signal into the input on your reverb processor, out of the output back into the input effects loop on the p.a. head, kinda like you would a effects pedal thru the effects loop of a guitar amplifier. hope this helps!

Contact Peavey directly for the best answer. Here's the link- Peavey com

You would come from the output connectors on whatever amp or powered mixer you're using to the full range 1/4" phone jacks on the back of the speaker cabinet.

You should contact Ppeavey customer service. Here's the link- Peavey com

According to this https://en.wikipedia.org/wiki/List_of_Peavey_guitars#Bass_guitars it is a 1989 model. It was a very good year. .

Depends on the end result you want. If you're using a high impedence mic or a low with a transformer,jst plug it into the input jack, drop the gain down and contriol your violume with the master. A better way would be to plug a small mixer into the effects loop/line in jack.

You should be able to connect the XLR l&r outputs to the amp or the 1/4" l&r outs to the amp. Check out the manual here. http://assets.peavey.com/literature/manuals/FX_Mixers.pdf http://assets.peavey.com/literature/manuals/FX_Mixers.pdf

Peavey Fury IV wiring diagram Peavey Forum Hope this helps

It should be a 5 amp fuse, and usually states that around the fuse holder on the rear.

Unfortunatly this could be any of a number of problems. i suggest taking it to the repair shop.

There is an external speaker jack on the back. Plug in a cab of your choice down to 2 ohm load. enjoy.

Contact Peavey customer service at this link- Peavey com

This is not user servicable. Here is a link to the service locator for peavey- Peavey com

look here, http://www.ko4bb.com/manuals/index.php?dir=06_Misc_Test_Equipment

Peavey com contact peavey directly and they'll send it to you.

Contact Peavey Customer Service. They can email you the schematic, and you can get the part directly from them.