20 Most Recent Peavey Sanpera I Amp Pedal - Page 7 Questions & Answers

Pedals operate at a different level then rack units that go in the effects loop. It needs to go in front of the amp input. Guitar to pedal to amp input.

Normally on older Peavey amps the grill is on a frame attached to the face held on with velcro. I suspect you have something vibrating against the speaker if it's only one frequency. Once the grill is off it may be apparent. Also on old Scorpions and Black Widows Peavy has a piece of foam in the hole in the magnet to keep junk from getting in the speaker. Over time it crumbles and opens that hole, but even worse can get it the gap and freeze the voice coil. I always suggest cleaning it out while the speaker is out of the cab.

http://www.schematicsunlimited.com/p/peavey/

I think you may have a bad input jack, or it has come loose from the circuit board.. If you need to take it to a repair shop, ask about their bench charge. It may be cheaper to just replace the amp.

simple !! most peavey mixers have a monitor output !! you can use that to feed new amp , and theres your volume too !!! or if your already using the monitor output , you can buy a split cable (1 in 2 outs) for main send !! this cable would have to be kept short or it will induce HUMMM !! and in real extreme cases if your using a low Z send (cant think as to why ) a device known as a (direct box) normally used by instrument sends can be used in reverse to "tap" into a low Z send and output with a unbalanced send for an amp to your other room , but hey why not just add a speaker with a volume control to it for this smaller room ? and forgo the new amp

WHEN THE YELLOW LED IS ON ALL THE TIME, IT MEANS ITS ON PROTECTION MODE MEANSNG IT HAS A FAULT. U NEED A TECHNICIAN TO CHECK AND CONFIRM THE FAULTY COMPONENTS.

No, not if you're used to taking mixers apart and soldering to traces. Get the schematic and parts direct fromPeavey.

I'm pretty sure that model has active - battery powered - pickups, and yours is flat, so no output at all. The battery would be under the smaller cover plate on the back http://resources.ibanez.com/resourceservicehost/images/Ibanez/web/insets/zoom/SR300SLB_Battery_Box.jpg

Question?

On the front panel there will be a Line Out jack. That's the connection point. You may have to experiment with the gain control on your mixer to get the levels right.

First, check that your source is producing sound by plugging into a different speaker set. If so, plug your source directly into each of your three speakers individually to see just where the problem is. I would suspect the crossover in the sub speaker .

PEAVEY KB60 Service Manual free download schematics eeprom repair info for...

Assuming you have tried other cables and speakers to be sure it's the mixer, I would suspect the output power section is dead. Time for the repair shop.

After quite a bit of searching around, I stumbled across this cab and figured you usually can't go wrong with Peavey (for durability anyway) and coupled with 2 Celestion Green Backs for this price?! Had to give it a shot. Glad I did. Very versatile cab, can run 16 ohm stereo or 8 ohm mono, removable back so can run closed or open. Just what I needed. I run mostly open back, just my preference, but closed back sounds pretty decent, much more punchy.

This will not be user serviceable. Here is a link to find the nearest service center- Peavey com

generally it's either on the headtock or the neck plate.