Top 20
Printronix Line Matrix P5210 Printer Questions & Answers
Could you provide me the Windows 7 64bits for P5210?
There is not a windows 7 driver for the P5000, but the P7000 driver has been fully tested by Printronix to work with the P5000. Alternatively you can use the printer in Epson emulation mode and use the Epson 1080 driver included in Windows7.
Printronix p5210 firmware
Hello Fadel,I emailed 2 different Emulation files...Let me know if you receive an error. If you get Flushing Ques after you started the download, then you don't have enough Dram memory, Flash memory or Security Pal chip needs a specific Emulation file.
Hi i wan to download
www.printcountry.com/drivers/PRINTRONIX_P5220_GOLD_SERIES_2000_DRIVER_DOWNLOAD.htm
-----------------------------------------------------------------------
driverscollection.com/?H=P5220&By=Printronix
----------------------------------------------------------------------
http://driverscollection.com/?H=P5220&By=Printronix
-----------------------------------------------------------------------
http://www.printcountry.com/drivers/PRINTRONIX_P5220_GOLD_SERIES_2000_DRIVER_DOWNLOAD.htm
----------------------------------------------------------------------
tyr anyone of these
Characters out of alignment
OFTEN the cause of alignment problem is that the paper tractors are too loose and paper moves more than it should. It takes careful adjustment of the tractors to hold paper just right when the hammers hit the characters. Too tight and the tractors tear out the edges, too loose and characters rattle around in alignment.
OTHER problems can be caused by TOO LOW humidity which causes electrostatic attraction and drag. SOMETIMES they use an ionizer bar and the high voltage power supply goes bad. Another thing is drag from the stack of paper source.
Tech menu for hammer phasing
You can check the user's manual for the information. Here is the link for downloading:
http://www.printronix.com/products/productmanuals.aspx?id=4108
Printronix P5210 line printer HOF problem
If you are using a printer that has IGP enabled, you can set the printer to automatically go to the next TOF at the end of the print job. Only if you are using the Graphics portion (printing bar codes and graphics). The option is "Auto FF at ^PN" and you would Enable it.
P 5210 problem
Have you tried reducing the machine to the basic unit and restarting it (take out any options and just reset the memory sticks). If it restarts, with a minimal configuration (like troubleshooting a PC) then just add things back, one by one until you find the culprit.
Not finding what you are looking for?