20 Most Recent Printronix Line Matrix P5210 Printer - Page 2 Questions & Answers

If you are using a printer that has IGP enabled, you can set the printer to automatically go to the next TOF at the end of the print job. Only if you are using the Graphics portion (printing bar codes and graphics). The option is "Auto FF at ^PN" and you would Enable it.

Have you tried reducing the machine to the basic unit and restarting it (take out any options and just reset the memory sticks). If it restarts, with a minimal configuration (like troubleshooting a PC) then just add things back, one by one until you find the culprit.

See this post:

http://www.fixya.com/support/t746596-shuttle_jam_see_manual_problem

You can check the user's manual for the information. Here is the link for downloading:
http://www.printronix.com/products/productmanuals.aspx?id=4108

If someone taps the advance button instead of holding it down it resets. The solution was to reboot the printer..

Download owner's and programmer's manuals directly from www.printronix.com

Steve W
LazerTek LLC

Purchase and install a wireless print server.

Lazertek

You will need the factory service manual available for purchase from your Printronix dealer.

Steve W
LazerTek LLC

Purchase and install a wireless print server - available from many manufacturers.

Steve W
LazerTek LLC

Call 800-854-3181 to talk to a LIVE tech support which is located in the US.

My P7005 displays PAP FD DRVR CIR error

Hi Either the power supply is not generating a proper 48 Volts or the controller board is not detecting a 48 Volt output from the power supply board. 1. Make sure the power supply board is correctly connected to the controller board. 2. Power on the printer. If the message appears, do the power supply operational check (page 195). If the power supply fails the check, replace it. If it passes the check, go to the next step. 3. Power on the printer. If the message appears, replace the controller board. Record the message and return it with the defective board.

The shuttle is actually the print head.If turning machine off and then back on doesn't fix the problem then you will have to replace the shuttle.

This is usually due to a bad main board. Occationally you can reload the microcode to fix it but not normally. Get the part number off the main board as there are 2 kinds and they are not easy to intercahnge.

An ******* or unsupported instruction was attempted in the application program. 1. Cycle Power. Run the print job again. If the message appears, load the latest emulation software. 2. Cycle power. Run the print job again. If the message appears, record the display message and send it to your next higher support facility.

Based on your error you could have a P7000 or a P8000, Either way it is normally the main logic, but there are 2 for each machine. P7000 V5 PRINTRONIX 250299 001 HURRICANE V5 PPC P7000 New P7000 V6 PRINTRONIX 253081 991 LOGIC PPC V6 P7000 EXCHANGE New P8000 LS P8000 HS PRINTRONIX 257114 001 CONTROLLER BOARD P8000 New PRINTRONIX 256443 901 CONTROLLER SUBASSY LS 5 10 New