20 Most Recent
Kyocera KM-1505 Copier - Page 4 Questions & Answers
I am getting the message Joo what could be my problem?
not takeing paper from cassette the first sensor from pick up is durty or the actuator spring one the sesor is hooked out it is setuatedjust unther the drum unther the white registration gaide roller to remove it to remove it remove the image unit remove back cover remove registration clutch remove white registration roller clipout the sensor
A 400
laser unit error claen the laser inside if the 8 side mirror inside the laser is not turning remove the laser 8 side mirror and turn the black plastic pin to remove the 8 side mirror sjaft lubricate the sjaft so the mirror spin freely put everything back if error is stil there replace the laser it will cost you over R4000
Error AP
ap meen adding powder ti will go on until there is enough toner added to the developer if the developer is to old or not enouth it may go on for very long maybe 10 min the copys my become durty or very light and developer must be replace by a technician
The print on the right
on today digatal machines what you put on the glass is what you get out there is now need to put it darker in this order you mirrors is durty ,the laser **** glass or laser inside is durty ,developer is not enouth ,drum need replacement.
My km 1620 shows a
every 150 000 copy the maintance light comes on then the technician need to do a maintanace were he replace the maintance kit MK410 u may go a few copy over until the kit get replace i did find some time 2000 over some one did not replace the kit and went over to far and the high volts board blow it cost them twice as match the a new kit
Kyocera eroor code c-6 400
Hi,
This could be a fuser housing error, usually associated with dirty AC power. This could be due to a faulty PWB.
You could try running this self reset though:
- Switch off
- Open Toner Cover
- Switch on, holding System Menu
- Go to Secure Setting
- Enter
- Hold Start # Enter
- Scroll down to Maintenance Mode
- Enter
- Scroll down to U163
- Scroll down to Execute
- Enter
- Close Toner Cover
- Leave run for a few seconds
- Switch off
- Switch on
Hope this helps,
Regards
Mike
Kyocera
Kyocera Mita copier problem? tawag lang po sa number na ito 09483879552 or 09154815219NAg aayos po kami kahit anong klase ng kyocera mita copierspara sa karagdagang detalye tawag lang po ormag text sa mga number na nasa itaas ...salamat
"C6000"
You have a bad FUSER assembly.
Erreur c7 980 kyocera KM-1500
Waste toner reservoir overflowprobrem (when the total number ofcopies is less than 100 thousandsheets)• After E31 is displayed, 1,000 sheetsare copied. Or waste toner exceeds 5g.
Not finding what you are looking for?