20 Most Recent
Konica Minolta magicolor 5430 DL Laser Printer - Page 3 Questions & Answers
Hello. I am getting a
It won't print anything if one cartridge is empty, even black when the colour is empty. Are you using new or refilled cartridges? The cartridge has a chip on top that counts your number of prints, so it could feel full, but has reached it's end counter. Try another cartridge. That should solve your problem
Konica Minolta 5430dl wrinkles paper when printing
suggestions=
check the tray, that papers are properly inserted in the tray,
papers should be moist free,
this problem can also be caused by dusty pickup rollers, which picks the paper and also due to fixing unit problem.
I changed my trans roller on a magicolor 5440DL pr...
You can reset the transfer roller counter under the menu for the printer. To do this:
1. Press menu.
2. Push the right arrow twice to get to "Engine"
3. Verify Engine is the option displayed and press select/enter.
4. Scroll through the menu until you see "Engine Service". Press select.
5. Scroll to "Reset Counter Transfer Roller". Press select.
After pressing Select on step 5 it appears to run a calibration (at least it did on mine.) But the message should be gone after that. The counter for the transfer belt is also here. Please be sure not to reset the wrong one.
I hope I've done a good job answering your question. If you have any additional questions I will do my best to answer them. If my answer was helpful for you I'd appreciate a 5 thumbs up rating, or a click on the yes this was helpful button. Thank you!
How do I print 8-1/2
On the 5430 DL there is an aux legal tray that can be purchased for legal printing. On a later successor the 5550 a manual feed option was included, however for the 5430 there is no option for printing legal without the extra tray being installed. On a side note, I have this tray and when not printing legal it lets me load an extra 500 sheets of letter paper which is very convenient when I need to print a bunch of sheets overnight.
Streaks and black spots on printed pages
Try cleaning the laser lens using the laser lens cleaning wand. However, it is likely that your black cartridge needs to be replaced based on the troubleshooting from the Minolta manual. Sorry,
New toner cartridges were inserted and they are
You need to make sure that all sticker removed from the ink and that the vent are clear…some of the issue may cause the printer to give wrong reading especially if you touched the ink sensors or got ink around the housing from outside, as far as the level if you ran the alignment or self-cleaning that use lots of ink too
....let me know if that work for you and please do not forget to rate my service so I am able to continue providing same...god bless
1 thump not related
2 thump related but no recommendation
3 thumps related worked some issues
4 thumps related worked all issues and satisfied
Duplex unit not attached
Hi there
duplex unit is another part that you can buy to add on your printer, if you have one on it and it not show up see if the plug is in thight
Magenta toner not installed but it really is
I have to ask this question of you, just to make sure this is not an issue. Are you using a factory new ink cartridge?
Please consider the following:
If you are using a refilled or third party cartridge that may well be your problem. Most manufacturers build logic into their products to prevent the use of “Other Equipment Manufactured” cartridges as well as re-filled cartridges.
They do this to prevent problems from contaminated inks causing problems with print quality or damaging the physical printhead.
If you are using factory new cartridges, then please call the manufacturers Technical Support for assistance with the warranty on the cartridges
Don
Not finding what you are looking for?
