Pioneer AVH-P5700DVD Car DVD Player - Answered Questions & Fixed issues

Question edited for model and correct model format. Try a Reset, page 14 https://www.pioneerelectronics.ca/pio/pe/images/portal/cit_11221/212667155AVHP5700DVDOperationManual.pdf There is nothing in the Service manual https://www.manualslib.com/manual/952324/Pioneer-Avh-P5700dvd.html Ask Crutchfield Live Chat. They supply all of these units. https://www.crutchfield.com/S-VaSDlO4MwRr/p_130AVHP570/Pioneer-AVH-P5700DVD.html ..

My car lcd touch not working top right side. So I'll tried my best.

It is most likely the ribbon cable and it is pretty cheap to ge tone but you have ot pay a repair tech to put it in for you.- You might be able to do it but you could do more damage and it may cost more that way ! Good Luck !

Your Pioneer may not be properly installed. There is a light green wire in the wiring harness that needs to be connected to the parking brake wire in your vehicle. If that wire is installed correctly, there may be an issue with your vehicle. Below is a link to the installation manual. http://www.pioneerelectronics.com/pio/pe/images/portal/cit_11221/212667143AVHP5700DVDInstallationManual.pdf

the video doesn't come on only the sound

Check to make sure the unit is getting good power and ground. If it tries to retract and fails, the mechanism may be jammed.

If you don't see the XM radio symble on the front, it doesn't have it...

i am having a problem, no video but having sound can you help methank you

you have to clean the debris out of the gap on the bottom of the screen

this is ur players logic boards problem service it

You can get one from either pacparts.com or pioneerelectonics.com. The part number is CNP8806.

Try visiting this site:
http://cgi.ebay.ca/Pioneer-AVH-P5700-video-bypass-Module-DVD-kit-new-P5700_W0QQitemZ230333866203QQcmdZViewItemQQimsxZ20090329?IMSfp=TL090329135001r4617

This is a safety function of the unit and cannot be changed, to my knowledge.

You need to go into the menu and check what the crossover levels are set for, you will find that the speakers are set to only reproduce the higher levels and not the bass.

you have to get an iPod cable that gives you RCA outputs. Just connect the RCA outputs from the iPod to the AUX inputs on the unit. I believe that should do it. Ebay sells the iPod cables, and most electronics stores should as well

if your looking to wire it through toogle switch instead of say ign. switch run the wire labeled 12 v. switched (i think usually yellow wire) through toggle and have toggle run off battery. (im taking it maybe you wanna do this so you can run player w/out having ign. switch on) remember that 12 v. constant (usually red) has to maintain power at all times to keep clock/memory on player.

calibrating touch screenProblem with Pioneer AVH-P5750DVD Car DVD Player

since that is a touch pannel command, you could first try reseting the unit and test. rest instructions are in this manual. thanks for using fixya.

This happens when you don't have a good enough ground

In order to calibrate the AVH-P5700DVD you need to press and hold the Boost and the + button and then press the reset button with a pen. continue to hold the Boost and + until the screen opens back up and you can see the calibration screen. use the arrow nob on the right to select the menu item, and the A button to select your item.