20 Most Recent Goldstar GVR-E435 VHS VCR - Page 2 Questions & Answers

The TV channel should be set on Chanel 3 or Chanel 4. Use the remote control of the TV to set it. You can also use the AUX ports (to TV) on the VCR and connect the three wires to the AUX ports on the TV (TV input). The two audio wires are to be connected to Audio in and the Video signal to the Video input. If you get a garbled picture you can use press the tracking button on the VCR. Usually you press the Channel Up arrow, or Channel Down arrow to adjust the picture.

hi,

how many years, your tv is working .

if over 10-15 years you must try to replace with new one.

if not :

the gun of screen lamp may be damaged or one of diod is damaged or one of the larg capacitor

is leeked .

anyway for solving the matter a technecian must visit your tv.


good luck

gorbesia

You could try Curry's Partmaster.

Possible failure of the main power supply to the TV . It can be a fault in the SMPS unit
Please check the link below:

http://www.fixya.com/support/r5826301-working_switch_mode_power_supplies

I should have a look at the Goldstar website. It might come under LG by the way. Makers often put free PDF's of user manuals there.

Sending the signal through the Shaw box should not in anyway affect it. The only problem that might occur is if you tried to record an HD transmission on a VCR not built to do so. Even then the only problem you would have would be a picture that would not be a normal size.

If you are having issues then either the Shaw box or the Sharp TV's connections are introducing some type of distortion. The best way to figure out which one is to take each one in turn out of the equation. As soon as the picture problem is reproduced you will know which is the problem.

Get a universal remote from your local department store..

Have a great day

Replaced fuse inside unit.

It all depends on the manufacturer. Some newer units may play both "-" "=" or " - + ". There are 3 diff types negative, positive and both. My advice go ahead and try it.