20 Most Recent Mitsubishi WS-55711 55" Rear Projection Television - Page 9 Questions & Answers

Do you have the model number available? It should be on the back or bottom of the unit. Before adjusting, clean the heads and verify that the tape is running at the proper height past each head. There are three head assemblies to inspect: the rotating video head, the stationary sync head, and the stationary audio head. The sync signal is on the top edge of the tape and the audio signal is on the bottom edge. If the sync head or an adjacent guide pin has come loose, that could cause tracking problems. Caution: the video heads are very delicate. They're located in the slots at the bottom edge of the rotating drum. Use a foam-tipped swab with straight isopropyl alcohol, and gently wipe the heads in the same direction as the tape goes (do not wipe perpendicular to the tape direction; you could snap the head off if it snags on the swab).

No error code 61 listed, only a 66 error code which indicates lamp issues: 66 A) Lamp did not turn on at P-ON sequence... Check CJ4 circuitry B) No Lamp Inserted............... No Lamp inserted C) Disconnected cable between ballast and lamp.... HV connection or lead wire to lamp. D) Lamp-Enable goes to PWB-MAIN but not to Ballast....Lamp Cartridge Failure for lamp see the following web site: http://www.shopjimmy.com/dlplamps?tv_brands_select=Mitsubishi&tv_models=Mitsubishi+WD-73638 recommend using the manufacture part# as many replacements for Mitsubishi will not work.

Shorted circuit board.

It might help to unplug the TV from the AC outlet for a few minutes, and hope that it's circuit resets itself.

Could be you need to set the output volume on your receiver for the soundbar. Most receivers allow volume output for each speaker

https://www.youtube.com/watch?v=_ONPuB5L-x4 https://www.youtube.com/watch?v=C9uA1DcyeNI https://www.youtube.com/watch?v=INird71KKtA

Go to this link, find the manual and follow the instructions. https://www.manualslib.com/

https://www.manualslib.com/products/Mitsubishi-Ws-55411-281606.html

BLINKING

https : // www . manuaiscenter . com / manuals / mitsubishi / hsm1000g - servi?o - manual . html #. XH5euon7QdU Detalhes

Do you see a small fan close to it? Is it gunked up with dust? It could be the bulb but it sounds like it isn’t getting cooled.

Yes, but if you leave it unplugged for at least 1/2 hour you should be safe. Use insulated tools or rubber gloves to be sure.

It's been a lot of years since I worked on an HS-U65, but I'm pretty sure it only plays NTSC VHS Tapes.

Try here: https://www.directutor.com/remotes/Mitsubishi_290P122020_Remote_Manual_Codes?page=160

Probably the code is 000.