20 Most Recent Mitsubishi WD-52725 52". Rear Projection HDTV - Page 2 Questions & Answers

Hello i link the part check this website..

hope it work's

http://www.discount-merchant.com/SearchResults.asp?Search=WD-52725

The green light flashing is an error code. Count the number of flashes and it will tell the issue. Write back once you've counted the flashes. Also, was the TV having any issues before this? Was there a recent storm or power surge?

HelloThe power regulator board of your Mitsubishi TV is faulty. There are two reasons for this fault. The fist one is with its internal protection fuse, and the second one is with component failure to the power supply board. To retify this fault, for both, you must ahve its service manual to follow. User manual provides details about how to use it; where as service manual will have all the details, circuit boards, schematic diagrams, porcieedings to take out and repair the boards, components and it values etc; I can't send the service manual to you by this window. If you want to do this work by yourself, you must have it with you, while I advice you to proceed the work. To get it, you must have to buy one amoung my service published in FixYa website, or go to Google and typw my nickname "gopakumarg43" in its search box. Click on the link "gopakumarg43 - FixYa". You can access my services there. Fixya has placed me on Google, from where you can get straight to me, by mail assistance. I can't touch you by mail, as it is against our Primium Expert's rules and regulations. The power supply of your TV should be checked. If you have knoledge in electronics and have a concept of soldering, get me by Fixya. OK.

you can get the Mitsubishi WD52525, WD62525 Training Manual from www.tvrepairworld.com under the service manual category which includes the factory training manual and also the factory service manual

It is doing this because the filter cover on the side of the tv has come loose, or the microswitch that senses the cover has gone bad. It is at the bottom right corner of the filter cover.

The 1000uf 16v capacitors on the dm board are probably bad. There are 4 of them. They are about $1.75 each at radio shack.

I suspect you have a failed main power supply, this model may not be well-protected against brownouts or surges.
The main supply is usually a separate board and if you remove the lower rear panel, look for a board that seems to be related to the AC line and has larger components than the other boards. Some of them will be cylindrical and others block-like.
Look for a board number since this is a component that is often outsourced and may not be from the same manufacturer in every set. Call the nearest service center to inquire about repair or replacement costs

not always but 95 percent of time if you remove the bulb the bulb will be burnt out like a regular light bulb and or shattered. At the shop the first rule was always remove the bulb and look at it. DO NOT touch the front or lense part of the bulb.

Hello
make a System Reset process. To do this;
If the TV will not respond to either the remote control or the front panel controls and/or will not power Off, press the SYSTEM RESET button with a pointed item like the end point of a paperclip. The TV will turn Off and the TIMER light will flash quickly for about one minute. When the TIMER light stops flashing, you may again turn on the TV. The changes you made the last time the TV was on before you used the SYSTEM RESET button may be lost, however, the changes that were previously saved are not lost.
OK.

I suspect both of you have a failed main power supply, this model may not be well-protected against brownouts or surges.
The main supply is usually a separate board and if you remove the lower rear panel, look for a board that seems to be related to the AC line and has larger components than the other boards. Some of them will be cylindrical and others block-like.
Look for a board number since this is a component that is often outsourced and may not be from the same manufacturer in every set. Call the nearest service center to inquire about repair or replacement costs.

FYI the convergence ic's need replacing also any burnt resitors.
not a job for amateur, get a professional to do the job.

There are small surface mounted capacitors on the dm Board and the fmt board that have gone bad. They need to be replaced. Most tv techs will charge about $400 to do this.

Yes, no pitcher or sound

Hi:
This sound is an indication that the color wheel is faulty in the light engine, with mits sets you must replace the entire optics engine. You can purchased used light engines or have your sent in for repair. Try this site for rebuilt engines www.tristatemodule.com

Mitsubishi has repaired some sets if you have the origional purcahes documents. If not you can get the v26 DLP DM repair kit which should take care of that issue. Heres a link to the kit if needed.
http://servicemanuals.vstore.ca/product_info.php/pName/v26-dlp-dm-pwb-repair-kit/cName/repair-kits

your projector bulb went out. you need to call the manufacturer and order a new bulb. they cost 300 to 400 dollars a piece I believe your tv only has one bulb and they are really easy to install.

hope this helped
please rate well. If you need further help, reach me via phone at https://www.6ya.com/expert/mark_445a24324be9eb03

Haven't done anything as of yet. I saw many posts that stated it costs between 800 & 1500 to fix the problem with no guarantees on the repair or how long the repair would last. Still weighing my options.

I HAD THE SAME PROBLEM. I POWERED IT BACK ON BY UNPLUGGING AND THEN HITTING THE RESET BUTTON. AFTER ONE MINUTE OR SO THE LIGHT WENT OFF AND I WAS ABLE TO POWER ON.

I STARTED THINKING WHAT COULD HAVE TRIGGERED THIS AND IT STARTED AFTER WE HAD A SHORT POWER OUTAGE.

I HAVE NO IDEA IF THIS WILL WORK FOR YOU BUT I AM ON MY SECOND DAY OF NO BLINKING LIGHT: I WENT TO THE MITSU TV MENU AND RESET MY CLOCK... I PUT IT ON MANUAL SETTING AND RESET TO PROPER TIME AND I HAVEN'T HAD A PROBLEM. IT'S WORTH A TRY. I'LL KEEP YOU POSTED..


JM947

JM947

Hi,
It is Y sus problem on your Tv. Please replace the y sus or get it repaired at local TV shop.
Regards, Jay