Life Fitness 9500HR Treadmill - Page 4 - Answered Questions & Fixed issues

This sounds like a motor control board issue. In my experience I have seen it either speed up when it is supposed to slow down or you will get a pulsating or lunging type action in the running belt. There are companies available that can test and repair said board for a fraction of the price. You might check with Carolina Technical Services LifeFitness motor controller repair

I would suggest swapping the consoles to see if the problem follows. If this does not help you figure it out, you are more than likely looking at a wiring issue.

You can get repair service from www.gympart.com

Check the 6v battery. If you're getting 6v or more, you have a faulty console. Not sure if you want to fix as the console is pretty expensive unless you can get a used one. Try Usedtreadmillrepairparts.com. They sell used parts.

rUN the software calibration for easy diagnostic and fix it. or go under the HOOD motor and follow the steps or read your owner manual. God bless you

replace dispay pcb

book an engineer, sound like motor controller, loose belt could also be a issue, needs a safety check where are you based ?

worn belt and deck

emergency stop switch missing or defective

see the video attached. and fix it. God bless you

see the video attached. lube the rollers bearing too front+backHowever RuN THE software calibration for easy diagnostic and fix it. see the diagram attached for s.sensor.God bless you

see the video and lube too the rollers bearing front+back

God bless you

LUBE THE DECK BELT, ROLLERS BEARING FRONT +BACK SEE THE VIDEO. ATTACHED.GOD BLESS YOU

see the diagram and proceed according.God bless you

LUBE the deck belt+rollers bearing too. If the problem persist, after you lube, TIME to replace the old boad deck.God bless you

Please Help,I have just bought a used treadmill life fitness T3, and i have jut put it on but in the top its saying Replace the emergency stop switch, i don't know what it means as this is the first time i bought one :(

This indicatin is problem with the speed sensor, see the diagram attached, test the s. sensor for open or faulty. clean it, and tigh the plug or connector very well.Try to run The software calibration for easy diagnose,troubleshooting, and fix it. God bless you

Says to lube belt did that but still saying lube belt. Won't run when the safety key is put in

adjust the speed sensor , see the diagram, clean it , and tight the plug or connector very well, and test it and replace if necessary2) measure the input voltage for motor, if there are the motor need repair, see my personal TIPS3) test the output voltage board, for input voltage motor, if there are NOT the board is faulty, see the b. diagram attached..God bless you

RUN the software calibration for diagnostic, troubleshooting and fix it.2) LUBE THE deck belt3) LUBE the rollers bearing4) adjust the speed sensor see the diagram, clean it, and tight the plug 5) adjust the REED swtich see the diagram, clean it, and tight the plug.6) see the block d. God bless you