20 Most Recent Timex 27191 Wristwatch - Page 5 Questions & Answers

A jeweler's press provides an equal amount of force around the edges of the watch back without putting that same pressure on the watch crystal (which could cause it to crack or break). If you have a flat crystal, you might have success in putting the watch between two pieces of wood and using a regular vice to very gently push the front and back together. However, you risk doing damage to your watch crystal.
Your safest bet may be to go to a jewelry store or jewelry counter in a department store and ask if they could close the back for you with the proper tool. You may have to tip them a few dollars, but that is still far cheaper than the cost of replacing a broken watch crystal.

The links will have locking pins holding them in place, unless you have the required expertise / tools - would suggest not to attempt doing this yourself.

You will need to slide the locking pins out, in the direction of the arrow and the links would disconnect. Once you have the required number of links disconnected, you can go ahead and remove the latch from the last link and reconnect it to the new link! :)

Your watch is water resistant to 50 metres. There should be a wave symbol etched in to the back of the case.

WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS OR PULL OUT THE CROWN UNDER WATER UNLESS YOUR WATCH IS INDICATED AS 200 METER WATERRESISTANT.

Watch is here to confirm: http://www.timex.ca/Womens-Dress-SK27191-P193.aspx?l=e

Your Manual:

http://www.timex.ca/Womens-Dress-SK27191-P193.aspx?l=e

Price: $60.00

You can find the manual here..
http://www.timex.com/info/Product_Instruction_Guides_Downloads

Hello,

Thank you for using fixya.com

Looking at the movement side of the watch with a loupe, look at the area where the winding stem comes through the case and into the movement. If you zoom out a bit and look about the surface of the movement "USUALLY" in a quartz movement you will see an arrow pointing to a brass or polished steel button. This button is normally perpendicular to the stem axis. Sometimes however it could be a screw. You need to depress the button with a plastic stick while gently pulling on the stem. For a screw obviously unscrew but only enough to remove the stem NO MORE one or two turns are sufficient. Once the stem is removed you can remove any case attachments and remove the movement and then determine how to remove the hands and dial.

I hope this helps.

You can get instructions from the Timex web site "timex.com".

At the bottom of the screen click on "manuals/downloads", then on "product
manual download"

Enter your watch type in the search box and click on "search"

remove the crystal and manually move the hands 3-4 hours backwards. That should do the trick!

There are two ways to find the user manual for your Timex watch.

1. Find your watch on the list below and click on the language link for your manual.
2. Find the 3-digit module number located on the caseback of most Timex products and click on the corresponding language link for that number in the Module Table.

If you are still unable to locate your user manual, you may emailTimex Customer Service or call us toll-free at 1-800-448-4639.http://www.timex.com/info/Product_Instruction_Guides_Downloads

http://www.timex.com/info/Product_Instruction_Guides_Downloads

mcdevito75 Here, I may be able to repair your Timex watch but I will need more info and of course the watch here with me in Florida, I am RITE TIME BASIC here in the service directory at Fixya. Is your Timex a quartz / Windup?? did the stem simply pull out of the watch?? Contact me at [email protected] or here at Fixya.com

This a job for a jeweler, he has the equipment to work with the miniature parts that require a steady hand and lots of skill.